yes. loosen the locking nut, adjust the screw / bolt down to increase psi, out to decrease psi.
well most homes should have 60 to 80 psi. If you have a well and you only have a two story home then I would set the pump pressure to 60 psi, if you have city water and your pressure is above 80 , I would recommend installing a pressure reducer valve with shut offs on both sides so a person can service it in the future.
For many homeowners, the water pressure at the house is not sufficient to properly do household chores such as watering the plants. It is quite simple to check and adjust the water pressure. A pressure gauge can be purchased at a home improvement store. This simply screws onto an outside spigot and will give the homeowner a reading as to the pounds per square inch of water pressure. If this needs to be adjusted, there is a simple screw setting at the location of the main water line. Care should be taken when adjusting the pressure as too high of a setting can damage the plumbing.
Ferrous metal piping
poor water pressure from your city. Or if you are on a well, the pump might be going bad.
Area water authority could have increased water main pressure, no or defective expansion tank in house main water line if house has a backflow preventer installed, or defective /not properly set pressure reducing valve.
If it's a bladder tank, it should always have "Air" pressure but if the pump isn't working, you still wouldn't have water in the house.
House water pressure should be around 50-60 psi.
To allow the air pressure inside the house to equalize with the air pressure outside in hopes of reducing damage. However, this has been disproven. The pressure drop in event the strongest of tornadoes is not enough to cause significant damage, and even then then the winds of such a tornado would destroy a house before it reached the center where the pressure is lowest.
If it's the whole house, turn the screw clockwise at the PRV to increase the pressure. If it is something else, you would have to explain it more.
Possibly a pressure reducing valve installed after piping for first faucet, which would cause situation describing.
find an area where you can wedge the blaket to stay in place and get one blanket to cover the top only and make the house bigger by adjusting the are -melissa
The word for adjusting or fixing the position is "orienting" (to orient, to align). Metaphorically, it means adjusting one's perspective to a new situation ("Freshman orientation"). Example : "He was orienting his house plan with the vacant lot."