answersLogoWhite

0


Best Answer

no. it happens all the time. you just reset the timing, install a new belt and youre done.

User Avatar

Wiki User

โˆ™ 2005-12-15 04:04:44
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Would the engine on a 2001 Toyota Camry 4 cylinder be damaged if the timing belt breaks before it is replaced?
Write your answer...
Submit
Related questions

When do you replace a 1999 Toyota tacoma 6 cylinder timing belt?

Before it breaks


Ignition timing on 6 cylinder 5 speed 1994 Toyota 4 runner?

10 degrees before TDC


How damaged does carpet need to be before Farm Bureau will include it in a claim?

If the carpet was damaged from a listed peril (smoke, fire, etc.), the average policy will pay (after your deductable) to have it cleaned or replaced, depending on the damage.


What should it cost to replace a Toyota Rav 4 exhaust system?

I just replaced mine, came to $1080 before taxes.


How do you get the Diodes replaced in a damaged Alternator?

I can't believe the people that don't state make, model, year and engine size before posting a question.


How many O2 sensor does a 1998 Toyota Camry 98 4 cylinder?

It has two of them. One is before catalytic converter and second one is after.


You drive a Mitsubishi Pajero engine 4D45 Its clutch master leaked you replaced the parts inside the master pump After 10000km the leak comes back What if your comment please?

did you hone the cylinder before you replaced the parts


Why is one heater hose warm and the other one cold?

your thermostat is not opening and needs replaced before the engine overheats and damages the cylinder head/s


What is the timing for a 1989 Toyota Cressida 6-cylinder?

my service manual says 10 degrees before tdc on auto models with ac off idle @750


Can a bad wheel bearing cause a tire to fall off the car?

If any one of your wheel bearings are damaged or wearing then they should be repaired or replaced before anything bad happens.


What is Toyota's corporate strategy before 2009?

Sell you Toyota -


How do you bleed brakes on a 2001 Saturn sl1 Pedal goes to floor replaced master cylinder and cannot get pedal up even after bleeding?

The master cylinder MUST be bleed first before any bleeding at the wheels can occur. if you do not do this, you will be bleeding for hours.


How do you repair a Blown head gasket on your 1994 Buick century 4 cylinder?

The 1994 Buick Century 4 cylinder head gasket will have to be removed and replaced. The head has to be removed, along with anything that is physically in the way of removal, before the head gasket can be removed.


Where is the engine serial number of Toyota SUV diesel engine locate?

I found mine on an older Toyota diesel 4 cylinder at the top of the block right before it mates with the head. It's right under the exhaust manifold. Not sure how easy it is to see with it on though.


How do you stop Toyota hilux pulling to one side under braking?

Usual cause for brake pulling is Caliper / cylinder is not working on opposite side of pull, or brake line hose has collapsed internally---i.e.=Not letting that caliper /cylinder release fully from the previous application---thus being almost "on" before you hit the brakes. SOMETIMES this happens on alternating sides----very hard to diagnose. Hoses should be replaced as a set for each side of the car/axle.


Can your lung be replaced?

No your lungs cant be replaced because you ll die before you can.


Where is the bank 2 sensor 1 located on an 03 Toyota highlander?

bank2 is opposite side of the cylinder 1 and sensor 1 is before catalytic converter so the 1 near the radiator on the top


1992 Toyota Camry and the air conditioner blows hot air you have the ac switch on but you dont think the compressor is kicking on What can you check before getting it replaced Thanks?

Possibly a low refrigerant charge


After how many miles does a Toyota Hi ace need to do before a timing belt change?

The timing belt should be replaced after about 70,000 miles. This is when things begin going wrong in the mechanics and it is best to avoid this.


Is any programming or additional adjustments needed after a new egr valve is installed in a 2000 Toyota Camry 4 cylinder?

No but if there is still an EGR valve problem then its the EGR Valve switch located at the back of the motor. I replaced my EGR valve 2 times before I figured out it was the electrical switch, which had burnt up, for the egr valve. I havent had a problem with the EGR since then..


Where is the bank 1 O2 sensor for a 2003 Toyota tacom v6 pre-runner?

Going to be on the muffler after it leaves the engine, but before the two sides come together into the tail pipe. Bank one is the side where the number 1 cylinder is. (look on the distributor. It usually says the cylinder number on it.


What should be done before transferring refrigerant to an empty cylinder?

The cylinder should be evacuated


Should the cylinder ridge be removed before the piston?

No, you dont need to remove the cylinder ridge before. I never have and i replace them all the time.


What is the definition of damage to rented premises to you?

Your lease will specify what constitutes damage, but most landlords will consider any matter that must be addressed before the next tenant can move in as damages. If it needs to be painted, repaired, or replaced, it is damaged.


How do you replace a ignition key cylinder on a 1998 Toyota Camry?

You need to disconnect the battery, after that remove plastic and metal cover underneath the steering wheel. After that you get access to the key cylinder, disconnect the harness, remove nuts. Install a new key cylinder, tighten the nuts, connect the harness to. Install the plastic and metal cover. Connect the battery. You might want to try the cylinder before installing plastic cover.

Study guides

๐Ÿ““
Create a Study Guide