answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2007-02-05 18:07:19

If it only happens when you're in gear, maybe your torque converter isn't unlocking and is causing it to stall at a stop.

001
🙏
0
🤨
0
😮
0
😂
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

Have a 1988 d 100 that keeps stalling have replaced the fuel pump?

check throttle plate builds up with carbon


Why is my car is stalling I just replaced the battery.?

You might own a Daimler-Chrysler product. Consider cleaning (the inside of) the throttle body.


Car stalling in a Mercury Cougar when slowing down?

If you have the 99 -02 Cougar replace the TPS (throttle positioning sensor) on the throttle body.


If your car started stalling shortly after the AC stopped working and is still stalling after the throttle body was cleaned and ignition coil replaced could the AC problem have something to do with it?

The ac could be causing the problem. Turn the ac off, and watch the compressor clutch to see if it is not engaged. If it is then the compressor or clutch could be bogging the engine down.


Why is a 03 gmc envoy stalling?

check the throttle body for carbon build up probably fuel related


What is the throttle position sensor adjustment?

It has to be replaced. no adjustments.


Where is a throttle position sensor on 2003 a trailblazer?

The Throttle Position Sensor is conneceted to the end of the Throttle Shaft inside the Throttle Body. P.S. The Throttle Position Sensor is part of the Throttle Body and must be replaced as a unit. Hope this helps ya.


What are signs of Toyota throttle body assembly going bad?

High idle RPM, stalling, low mpg, poor performance.


Whats cause of intermit stalling and diffulcity starting on 94 wrangler 4 cyl manual. stalls no warning lights in message center fuel pump does not acuate. replaced crank censor and ingnition switch?

If your 1994 Jeep Wrangler is stalling and having difficulty starting, there could be an issue with the throttle position sensor. A damaged TPS can also cause hesitation when accelerating.


Why would my 1998 dodge avenger be stalling?

Check your Idle Air Control Motor located under neath the Throttle Position Sensor.


How do you stop your jeep from jumping and stalling?

Give a little more throttle and ease out slowly on the clutch. If that doesn't work you may have a timing issue.


Where is the throttle position sensor on a 2006 Chevy Impala 3.5L V6?

The throttle position sensor is actually apart of the throttle plate actuator assembly and must be replaced as a unit.


2000 Jeep cuts off?

I HAD THE same problem.... 87,000 2000 grand Cherokee 4.7l when i let off the gas it might stall. happens 1 to 4 times a day. so far i have replaced the crank shaft sensor - it stopped stalling for 3 days $130 cleaned the throttle boddy free replaced the throttle position sensor $72 replaced the idle air control sensor $132 replaced the map manafold airflow sensor $125 no luck it is still stalling. by the way i have done all the work myself. it was about 30 minutes for most parts i just ordered a rebuilt ecu or pcu engine control unit. they program in the vin, mileage and part nbr so you gc will recognize it. $185 installed ECU 2 days ago...... so far so good. good luck


Why does the 1985 Thunderbird stall once warm?

85 THUNDERBIRD KEEPS STALLING. tHE ONLY WAY IT STAYS RUNNING IS WITH A LOT OF HELP. i MUST KEEP FEATHERING THE GAS PEDAL PUMPING IN GAS i HAVE REPLACED THE THROTTLE BODY, FUEL FILTER, DROP THE GAS TANK AND WASHED IT OUT. iDEAS?


Where is the TPS for silverado located?

The Throttle Position Sensor (TPS) is located in the throttle body a the end of the shaft opposite the throttle cable attachment. Some are permanent / no serviceable. Some can be replaced and with a little ingenuity/skill, even the permanent can be replaced as there are replacements available for all year models.


Where is the throttle position sensor located on a 2005 Nissan altima 3.5?

It's part of the throttle body, entire unit must be replaced.


What is throttle body service?

The throttle body on an engine houses the throttle, which controls the amount of fuel that enters the engine. It controls the engine's ability to maintain an idle, prevents stalling, and aids in acceleration. If the throttle body is dirty, it can cause problems with the engine running properly. During a standard service, sludge and carbon buildup out of the throttle body and off the throttle blade. The vehicle's computer is then hooked up to a special machine for an idle relearn procedure.


How can you fix a sticking throttle cable on a 1995 Ford Escort GT?

the throttle cable itself will have to be replaced. the cable is most likely fraying internally.


Change a throttle position sensor for 05 altima?

The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.


I have an 08' Aveo5 The throttle body keeps gumming up and making car surge at highway speeds What is causing it and how do I stop it?

Sounds like the throttle sensor, throttle body needs to be replaced.


How do you stop car to stall?

I think I understand what you are saying. If your car is stalling and you want to figure out how to get that to quit, have the idle and throttle checked out. Idle might be set to high. Also, the throttle body might need to be cleaned. A great website to figure out how to do this is at www.trustmymechanic.com


How do you reset a throttle body dodge magnum?

There is no reset. If failed the part must be replaced.


Why does the throttle cable on your Honda Recon have too much slack in it?

Needs adjusted or replaced.


What will cause a Jeep Cherokee to go dead and then re start?

I HAD THE same problem.... 87,000 2000 grand Cherokee 4.7l when i let off the gas it might stall. happens 1 to 4 times a day. so far i have replaced the crank shaft sensor - it stopped stalling for 3 days $130 cleaned the throttle boddy free replaced the throttle position sensor $72 replaced the idle air control sensor $132 replaced the map manafold airflow sensor $125 no luck it is still stalling. by the way i have done all the work myself. it was about 30 minutes for most parts i just ordered a rebuilt ecu or pcu engine control unit. they program in the vin, mileage and part nbr so you gc will recognize it. $185 installed ECU 2 days ago...... so far so good. good luck


How do you replace the idle control valve in a 2003 dodge ram 5.7 liter hemi?

The 5.7L Hemi does not have an idle control valve. Idle speed is regulated by the computer by opening or closing the throttle plate itself. The motor is a non serviceable part of the throttle body. The entire throttle body would need replaced if malfunctioning.The 5.7L Hemi does not have an idle control valve. Idle speed is regulated by the computer by opening or closing the throttle plate itself. The motor is a non serviceable part of the throttle body. The entire throttle body would need replaced if malfunctioning.