The timing marks on a 1994 Toyota Corolla are located on the crankshaft cover. The crankshaft cover is usually located at the very bottom of an engine.
yes, it is an 'interference' engine
injection pump crankshaft camp
Your 1998 Mazda 3.1 liter engine does not have timing marks on the crankshaft. The timing marks are on the engine flywheel.
Yes, there's a special tool that is inserted into the crankshaft during this procedure. See http://www.etoolcart.com/browseproducts/Ford-Cam-Positioning-Crankshaft-TDC-Timing-Pin.HTML If he forgot to remove the tool before he started the engine, it will do damage to the crankshaft.
The 1.8 litre four cylinder engine in a 1998 Toyota Corolla has a timing CHAIN
does a toyota corolla 07 1.8 has a timing belt or chain
The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.
No. It has a timing chain. the timing belt on my 1999 corolla has just been changed. it depends on the engine type.
It is called a spanner
Lucky for you, the 2001 Toyota Corolla comes with a timing chain and is good for the life of the engine. No need to change it.
Every Toyota Corolla manufactured from 1998 to 2012 Model year has the 1ZZ FE 1.8Liter engine with a timing chain, no belt, with the exception of the XRS Trim which had a high performance 1.8liter but still a chain, and Toyota sets no interval for changing it
By timing strap, I'm assuming that you mean the timing belt. The Pontaic Vibe uses the 1.8 liter engine also used in the Toyota Matrix and Toyota Corolla. This engine has an internal timing chain and does not require replacement. Keep the oil changed and drive that baby worry free regarding the timing chain.
The timing marks are on the timing belt cover on the front of the engine right above the crankshaft pulley.
My 1996 Corolla with the 1.8 4 cyl. engine has a Timing Belt. I think they all do. All the 1.8's have a timing belt. Even the current models.
The 1.8 liter four cylinder engine in a 2009 Toyota Corolla has a timing CHAIN ( and also the 2.4 liter in the Corolla XRS model )
The 7th generation Corolla 1.6L engine (generally the 4A-FE) uses a timing belt. Timing chains did not come back until the 8th generation Corolla and newer (1998 and up used timing chains).
The water pump runs on the timing belt. You have to take the timing cover off, remove the belt and then remove the water pump. If you reuse the timing belt, mark the belt with a spot of paint at the camshaft and crankshaft so that you can replace it and have the engine in time. If you need to replace the belt, make sure the engine is at top dead center on the timing mark before you remove the belt.
the mark on the camshaft timing gear needs to line up with the mark on the crankshaft timing gear to ensure the camshaft is in proper time with the crankshaft. Keep in mind that the marks will only line-up every other revolution of the engine due to the crankshaft spinning twice as fast as the camshaft.
NO, the timing change is designed to last the life of the engine. It is normally changed when the engine is overhauled. Not other maintenance is required.
The 2000 Ford 4.2 engine does not have any timing marks on the crankshaft. Instead, you have to use a timing kit to install a new belt.
The Toyota Corolla is equipped with a timing belt. Whether the need for a timing belt replacement is dependent upon many different factors. If the engine is not running at all you probably will need a timing belt.
Timing marks are generally found on the flywheel or crankshaft pulley. This indicator is used to set the timing of an engine's ignition system.
Near the bottom timing belt cover (on the top left).