You have a 2003 4 dr Dodge Neon Suddenly the electric door looks and trunk lock do not work you also can't use the remote switch Any suggestions?
Did you try checking your fuse?
This depends on the switch. A lot of older fireplaces have a millivolt valve with a toggle-switch sticking out. We usually remove the toggle switch and run the 2 wires that were connected to the toggle to a remote receiver box. This way any simple remote transmitter will act like an electrical toggle switch. Most receivers will recognize hundreds of thousands of signals so this is usually very convenient and takes about 3 minutes to…
How do you disarm the alarm on a 1992 Lexus 400 LS when you do not have the remote and it goes off every time you open the door?
Unknown if you are referring to the keychain 'remote' or the vehicle switch. If the remote: Check the battery in the remote for need of replacement, if it still doesn't work, check the fuse for the auto locks in the vehicle fuse box. If the vehicle switch: check the auto lock fuse in the fuse box, if good then the switch itself is bad.
When using the remote for a Hunter fanlight the light will turn on-off using the remote-but will not turn on using wall switch?
No - the fuel pump inertia switch ( shut off switch ) is a switch that breaks the electrical circuit to the electric fuel pump if the vehicle is " jarred ' enough It requires you to press the button down that is located on the top of the switch in order to reset the switch and restore power to your electric fuel pump - it's a safety device There also is a relay for…
· Front Guard. It is a protective metal mesh wire used to prevent the fan blade from any physical contact with foreign objects. · Power Controller. It is a circuit that controls the amount of power supplied to the motor. · Sensor. It is the input receiver that detects input signal coming from remote control. · Manual Control. It is a push button switch that controls manually operation of the electric fan. · Non-polarized Capacitor…
When installing a remote light switch one must first turn the power off. This will prevent shock or electrocution. Next, unscrew the plate currently on the wall and remove the switch and wire the new one with remote. Next remove the light from the ceiling and install the remote sensor. Place light cover back over light and turn power back on. Program and test remote control to ensure wiring was correctly installed.
the television has a switch that makes possible for it to light on an off, the remote control has a malty sensor that allow sensory waves to be detected in an immediate effect when pressing some of the buttons on the remote control, co ordination is carried by eclectic waves that allow stimuli as electrons pass through conductors allowing a electric flow of current.
Drivers side window on 2000 EXP stopped working suddenly you want to believe it is something other than the motor Tried swapping relays and still nothing Any suggestions?
When using the remote for a Hunter fan-light the light will not turn on-off using the remote-it will turn on-off using the wall switch but the fan will turn on-off using the remote Any ideas?
The fan is wired to the house wrong. Typically the red switch wire in the ceiling box will be nutted off and not used when a remote is installed. Sounds like, in this case, the fan light wire (blue) was connected to the red switch wire in the ceiling box instead of being correctly connected to the remote unit at the fan.
These remotes are based on "pin switch" settings matching between the remote and the receiver (ie: electric gates or garage door opener) Your remote has an access door to access its battery and dip switches. They are a series of many little white switches that are either in the "up" position or the "down" position, from left to right. The device you are controlling (gate or door, etc) has similar switches set somewhere in its…