Chevy Blazer
Chevy S-10
GMC Sierra
Chevy Blazer S-10

You have a 89 GMC Sierra 2500 350 engine with throttle body injection the injectors only drip gas when i turn the ignition what could it be if the injectors are good?

171819

Top Answer
User Avatar
Wiki User
2005-09-24 12:54:12
2005-09-24 12:54:12

Sounds like a bad fuel pump. This is a common problem with GM trucks.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

yes, yes it does no, its the crappy tbi systems. tbi stands for THROTTLE BODY INJECTION! it has fuel injectors and has to be treated as such. it is not carbureted.

User Avatar

Yes it does. It has throttle body injection. Jim

User Avatar

Cycle the ignition key on and off several times pausing a few seconds in the on position. This will prime the fuel injection system.

User Avatar

Do you take the steering wheel off to get to the ignition

User Avatar

Check the ignition module in the distributor.

User Avatar

how to remove cover to replace ignition lock cylinder and what type of tools do i need

User Avatar

= Fuel Injector, 1988-95 GMC TRUCK C SERIES [INCLUDES TRUCK & SUBURBAN] 5.7L = Where is the module for the fuel injectors located?

User Avatar

There is no non-fuel injected 1992 model GMC Sierra 4.3 L. This engine has TBI (Throttle Body Injection). It may look like a carburetor but it has an injector mounted inside the housing. It does have a MAP sensor and it is located under hood, center, upper engine area, below air filter housing, passenger side of throttle body unit, mounted next to valve cover.

User Avatar

The timing for this engine is electronically controlled and not adjustable

User Avatar

it is under the black plastic upper intake, that the throttle body bolts to

User Avatar

From 88 to95 it was called the "TBI", throttle body induction.

User Avatar

Air Injection Check Valve ( Passenger side bank 2)

User Avatar

Your 2000 4.8 liter Sierra might run rough at an idle because of clogged fuel injectors or a clogged fuel filter. You might also have gotten water in the gasoline.

User Avatar

Need to replace ignition coil "D" for my 2000 GMC Sierra 5.3. Need to know which coil is coil D. Thank you, Adam

User Avatar

The fuel injection is not getting gas. Fix or buy a new fuel injection pumb.

User Avatar

The EGR valve is located on the intake manifold,behind and to the passenger side of the throttle body.

User Avatar

adjust the idle screw on the drivers side of the throttle body turn it to the right to lower you idle turn to the left to raise it

User Avatar

It is in the fuse panel. It is the ignition fuse that goes bad and keeps the truck from firing.

User Avatar

You will need to take out the parts of the ignition and put in new parts. It is usually best to trust a mechanic to do this for you.

User Avatar

Yes, the owners manual details how to program your ignition to a new key.

User Avatar

Backfiring in any motor is either badly out of time or a burnt valve.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.