Head Gaskets and Valve Covers
Chevy S-10
Saturn S-Series
Chevy Blazer S-10

You have a 96 Saturn SC2 19 dohc you decided to change the plugs one day and the first cylinder on the left when your looking down on the engine was full of oil so you changed the valve cover gasket?

111213

Top Answer
User Avatar
Wiki User
2006-11-07 03:43:09
2006-11-07 03:43:09

I have a '94 and did the same thing after I replaced the gasket. If it continues to leak oil by the plugs, re-torque the center bolts from the inside two out. If that doesn't work, get some gasket maker ($3) and smear it along the valve cover gasket inside the holes and wait for it to cure.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

2008 Saturn vue xe miles 154000 and for this vehicle the belt has not been changed. Should I have concerns.

User Avatar

what the torque spec for the cylinder head on a 2003 saturn L300

User Avatar

How do you install 2002 saturn sl2 4 cyl

User Avatar

What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?

User Avatar

How do you change the serpentine belt on a 2002 Saturn Vue 6 cyl

User Avatar

( no ) The 1.9 liter four cylinder engine in a 1999 Saturn S series has a timing CHAIN

User Avatar

The 6 cylinder Saturns were equipped with the "Ecotec" engine, which used a timing belt. Timing belts fail over time, and Saturn recommends that the belt be replaced every 100,000 miles. The 4 cylinder Saturns all used timing chains. With recommended service and normal use, the timing chain should not fail. It is recommended that you replace the timing chain and sprockets whenever the engine is rebuilt, but otherwise, the timing chain is considered to be quite reliable.

User Avatar

2005 6 cylinder where is the thermostat located?

User Avatar

where is the slave cylinder located on a 2004 satern vue

User Avatar

underneath the master cylinder for the brakes in the engine bay.

User Avatar

There are no Saturn car dealerships in Canada. Roger Penske, the owner of Saturn, and GM decided in September 2009 to close all Saturn dealerships in Canada.

User Avatar

The Saturn Car company is now defunct. There is no main office for Saturn Car parts. If one is looking to purchase a part for a Saturn car, they should begin by looking at the local auto parts store.

User Avatar

Saturn is a gas planet. I really don't think saturn can change for people because it is in it's own world.

User Avatar

i am looking were the cooled start sensor is on a 94 Saturn is at

User Avatar

To answer this question we need to know from where on Earth you will be looking for Saturn.

User Avatar

The 03 Saturn Vue does not use a stand alone camshaft sensor. The system uses the ignition system as a sensor, tapping into the number one and four cylinder firing systems.

User Avatar

In Roman mythology, (greek mythology with the names changed) Saturn is Father Time, aka Chronos. (chronology) In Roman mythology, (greek mythology with the names changed) Saturn is Father Time, aka Chronos. (chronology)

User Avatar

If it has a 4 cylinder engine, there isn't one. If it's a 6 cylinder, I'm not certain.

User Avatar

Under the brake master cylinder.

User Avatar

All Saturn 4 cylinder engines have an internal timing chain. All Saturn V6 engines have a timing belt.

User Avatar

A 4-cylinder Saturn engine will typically last between 200,000 and 300,000 miles with proper maintenance. It can be further extended through a major overhaul.

User Avatar

A Saturn SL -- and every S-series Saturn -- has a 1.9 liter 4 cylinder engine. The SC2, SL2, and SW2 have a DOHC (dual overhead cam) engine; the SC1, SL, SL1, and SW1 have a SOHC (single overhead cam) engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.