You have a Mazda tribute 2002 The rear driver brake light doesn't work but same bulb works when light's are on Any idea what the problem is?
Most bulbs have dual functions. Take the bulb out and look at it. It should have two springs inside. and if one of the springs are broken replace the bulb.
How do you fix your lighting problem with your 94 Chevy Cavalier Z24 you have no tail lights dash lights or parking lights?
When i have stopped for a school bus do not pass until the driver signals you to proceed the red lights stop flashing or?
Your signal light on your 1998 dodge durango has a buzz and sometimes doesnt come on what may the problem be?
When you turn the key in your 94 chev pu the motor does NT turn over but the head lights come on no it doesnt have daytime running lights any ideas?
2001 Mazda tribute and your daytime light flash when you are driving down the road if you turn on the regular lights it stops flashing any suggestions on the problem?
Have you found the answer to this problem? My Mazda Tribute 2002 does the same thing but I don't know what to do. email@example.com I had the same problem a while ago. It's the day time running light module failing. The module is located up under the dash just to the left of the steering wheel. It's a bit of a tight spot to get to but easy to change. There is one electrical connector…
What could be wrong with your car if the brake lights work when the lights are off but when the lights are turned on the passenger side tail lights and brake lights completely go out?
This is usually a grounding problem. Either an insufficient ground to the assy or a positive to ground problem. As you mention the brake lights work with the lights off, it will probably be related to a problem with the "running lights" system. As you mention only a problem with the passenger rear, I would check for a poor ground related to that light assy or possibly one of the bulbs' internal filaments in that…
Why would the headlights go off on a 90 Eclipse after turning on the high beams but play with the switch a little bit and lights turn back on?
most ikly the high low switch is bad you will need to remove the steering wheel and inspect for damage to the switch even if no damage is apparent doesnt mean that's not the problem. buy the switch cluster and plug it into the harness abnd if the solves the problem install.******************* you must replace the whole cluster ......lights wippers turnsignals.....**************** if cluster uis not the problem see service shop.....
What causes the ABS and TCS lights to stay on in a 1999 Venture These lights came on after valet parking at a hotel?
How do you fix the reverse lights on a 1999 Hyundai Accent when all other lights and fuses work but when you shift it in reverse you get no reverse lights?
I have got an 1989 Buick Park Ave Electra that won't start The dash interior lights all come on as does the radio heater and ac When I turn the key dash lights stay on but all I get is silence?
If your battery is old, it could be the cause of the problem. The starter takes a lot of current to crank an engine. The fact that lights are working doesnt' give much info as to the state of the battery. Try blowing the horn, which takes more current, and see if that works OK. If it is weak, it is probably a battery problem. Try to jumper your battery from another car and see…
1999 Isuzu trooper lights come on when very cold anyone got any suggestions when i pulled out the relay the lights went off.?
Likely, check the fuse panel for blown fuses. if this doesnt solve the problem you likely have a short in the wiring under the dash. you also should check the bulbs for the interior lights, its also possible you have them switched to off, where they wont come on at all. check the one in the center of the vehicle to see if it has a switch, if it does make sure its set to…
95 Cadillac Deville The Right Brake light doesnt work when you brake but when I use the turn signal it works fine What could be the problem I changed the bulbs on both tail lights and nothing?
Ah yes, the infamous brake light switch is your problem. Underneath the driver dash, look right above the brake pedal, there is a little roundish kinda piece there that is the brake light activator. It should be fully compressed while the brake is at normal spot. If there is a small nub comming out the end of it touching the brake arm, that's your problem. Loosen the nut on the end and move the switch…