answersLogoWhite

0


Best Answer

If you are in Full time it is recommended not to go over 25mph that is probly why it shakes put it in part time you can go up to 55 mph in part time

User Avatar

Wiki User

โˆ™ 2005-11-08 05:59:38
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: You have a jeep liberty 2003 when you switch to full time drive the car shakes after it reaches 40 mph It is also noticeable in two wheel drive but less?
Write your answer...
Submit
Related questions

Is there a kill switch in 2008 Jeep Liberty?

no


How do you replace power steering pressure switch for Jeep Liberty 2003?

Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.


Can you switch a 2002 jeep liberty into 4wd while moving?

yes


Can you reset the oil light in a Jeep Liberty?

The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.


Where is the Radiator Fan Relay located on a 2004 Jeep Liberty Limited?

The 2004 Jeep Liberty radiator fan relay switch can be found on the back of the fan motor. The relay switch is attached directly to the fan motor.


How does centrifugal switch opens in capacitor start induction motor?

When motor reaches about 70% of its rated speed then due to centrifugal action switch get open


You want to turn on a light in your garage when your car reaches a certain distance from the wall?

You need to set up a pressure switch or a motion sensor switch.


How do you turn on foglights in a 2002 Jeep Liberty?

pull out on the end of the lights switch


What is error code 43 on 94' subaru liberty rs?

Throttle switch error


Where is the oil pressure switch on a Jeep Liberty?

Should be right above the oil filter.


What kind of oil do you use in your 2005 Jeep liberty?

The type of oil that should be used in a 2005 Jeep Liberty is 5W30. You can switch to 10W30 in the warmer months.


My 2004 jeep liberty fog light switch wont pull out to activate fog lights - worked great yesterday what's wrong?

My Jeep liberty fog lamp switch will not pull out unless the control for the headlights is turned on first. Could this be the reason?


Does the cooling fan come on when the key is on in 95 trans am?

The cooling fan comes on when the engine reaches a certain temperature and is controlled by a sensor switch that kicks the fan on when the temperature reaches the preset temp.


How do you put your iPad on silence mode?

The slide switch beside the volume rocker can be configured as either a orientation lock or a mute switch. If it is a lock switch, you can just hold down the down volume until it reaches the bottom of the scale.


Inertia switch location 2004 Jeep Liberty?

Jeep does not use inertia/reset switches.


Where is the turn signal flasher on a jeep liberty 2003?

It is part of the hazard push button switch.


Where is the wireless control module located on 2007 Jeep Liberty?

Back side of the ignition switch.


How do you reset the fuel inertia switch on a jeep liberty?

Jeep does not use inertia/reset switches.


What is a thermo switch?

A thermoswitch is the device by the radiator, that switches on the fan as soon as the engine/ radiator reaches a set temperature


What happens when a frame from a source MAC address different from 00a8d2e4ba27 reaches switch port 015?

The frame is dropped


How does a thermostatic switch works?

A thermostatic switch works by turning on when the temperature is below a certain point. A thermostatic switch will also turn off when the temperature reaches a certain point. Thermostatic switches are used for space heaters so that they do not overheat.


Where is the high beam switch located in the Subaru Liberty?

The high beam switch for the Subaru Liberty is located on the left side of the steering wheel. It is on the same lever that the cruise control is located. The lever is either forward or back depending on whether high or low beam is wanted.


How do you switch between games in gta episodes from Liberty City?

Using the load feature in the pause menu.


Where is the Park Neutral switch on a Jeep Liberty?

Inside the transmission, on the valve body. It is called a range sensor.


How do you reset the fuel pump inertia switch on a Jeep Liberty?

Jeep does not use inertia/reset switches.