Hi! My wife has a 96 stratus and the same problem just happened. Unfortunately the Relay is basically behind the stereo console and requires to take alot of the front dash off. Her case however I notices this. The break lights worked just fine. Under the steering colum you will see 2 screws one far left one far right (towards break and gas petal area). Take those out and the black guard above the break petal should come off with no force. Check to see if all the plugs in the back of the fuse box are plugged in all the way. Her case the top right one (blue colored) had slid out a little and this fixed everything.
Same flasher for left and right signals but a different flasher for the emergency flashers.
The signals and the emergency flashers have separate circuits, separate fuses, separate flasher relays. Start with checking the fuses, the bulbs, the signal flasher relay and wiring and if it still doesn't work it may be the signal switch is bad.
its either the flasher or the turn signal switch
The emergency flashers and the signal lights are separate systems. Each has it's own fuse, switch and flasher relay. If your turn signals light up but don't blink I would blame the signal flasher relay.
There are two relays, one for the emergency flashers, and one for the turn signals. Your turn signal flasher is defective and needs replacing.
The signal light circuit is separate from the emergency flashers. First check for a blown fuse, then check the signal flasher relay.
No, there is only one flasher which works both the turn signals and emergency flasher. It is located on the drivers side, under the dash, above fuse block, mounted on kick panel.
Probably turn signal flasher
Many vehicles use two flashers but not all.
For most vehicles the hazards and signals are two separate circuits, they have separate fuses and separate flashers. Check your signal light fuse and signal light flasher.
The flasher is mounted just to the left of the steering column. The turn signal and emergency flashers are built together on this model.
Some cars have two flashers, one for the signals and the other for the emergency flashers. Be sure you replaced the right one. Also check the fuse the bulbs and lastly the signal switch.
It has two flasher relays. One for the Emergency Flashers and one for the Turn signals. Replace the Turn Signal Flasher Relay located front seating area, driver side, under dash, mounted in fuse panel as it is defective.
There is two flashers involved, one for the signals and one for the emergency flashers. Perhaps you changed the wrong one.
4 way flashers and turn signals both have a "flasher can" in the system to make the lights flash the turn signal and 4 way flashers are controlled independantly of each other try replacing the flasher can for the 4 way flashers it is obvious that the bulbs are ok because they work on turn signals
either a bulb or the signal flasher relay located on the fuse panel usually opposite the hazard flasher relay
Under the dash by the steering column and there is likely two - one for the four way flashers and one for turn signals.
to everyone who has asked about turn signal flashers today. 90% of the time the flasher unit is plugged into your fuse block. it will be round, metal or plastic, or rectangular metal or plastic. it will say flasher unit on it. there will be one for the emergency flashers, and one for the turn signals. there might also be a fuse for each in the fuse box as well.
If your turn signal flashers stopped working, play with the emergency flasher button on top of the steering column. Our 97 Sable turn signals quit once and luckily I pushed the emergency flasher button in and out many times and the signals have worked ever since. But the emergency flashers don't work, but I can live with that.
replace the turn signal flasher fuse.
By flashers do you mean the signal blinkers or what???
Emergency flashers are a separate circuit. I would replace the turn signal flasher relay. To find it, switch on your turn signals and follow the sound. The flasher is probably worn. I hope this helps.AnswerWhat he said, or you have a bulb out...
The Fiero has two flashers from the factory, the signal light flasher and the emergency or four way flasher. These are identical GM style two prong flashers. There are many quality levels and even a few novelty flashers available.
You probably replaced the emergency flasher, so remove it & try your flashers; if they don't work, reposition the flasher & try your flashers. If they work now, then try to locate the turn signal flasher (ref. repair manual). Or...heaven forbid, you have a short or ground in your turn signal wiring harness (somewhere), where only an ohm meter and knowing how to use it will locate it. Good Luck!
Depending on year of vehicle - may have a separate turn signal flasher that may be defective