answersLogoWhite

0


Best Answer

Guess that wasn't it, huh? Sorry, no offense intended. Is the coolant full? is the thermostat working, heater core plugged? Need more info to go further, what else has been replaced? why did you replace the heater control valve? based on what?

User Avatar

Wiki User

โˆ™ 2005-10-11 01:04:16
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: You have replaced the heating valve on your Ford Fiesta and there is still no heating in your car?
Write your answer...
Submit
Related questions

Replaced thermostat on 24 valve 3.0 Ford Taurus and still over heating?

A thermostat is one cause of over heating engines.The "Related Question" below lists a few other suspects to investigate that can also contribute to overheating.


Ford Fiesta internal heating will not heat up?

Fiesta's have a common fault with the heater control valve failing closed. You can get a new one from Eaby for £15


If you have replaced the flapper but the toilet is still running?

New flush valve may be needed.


Oil pan silicon gasket replaced still leaking oil?

valve cover gasket


If a leaky valve in your heart can be replaced?

Yes. It can be replaced.


Why is the water still running in the tub when the shower stem is turned fully in shower setting?

The valve is not be diverting all the water. This valve may need to be replaced.


How is a three way valve used?

Used on heating/cooling systems. Allows uninterrupted circulation through heating/cooling unit or heating/cooling system using 3-way valve.


Replaced the pilot generator on a Laars lite and it generates 670 to 700 millivolts however pilot won't stay lit when releaseing the valve Is it a bad gas valve Is it worth the money to replace?

Assuming you are getting that measurement at the valve would indicate a strong pilot generator and if the valve still will not open then I would pronounce the gas valve DOA. To replace the valve cost can vary from $350 to $650 depending on the Contractor due keep in mind that you've replaced the Pilot Generator and now a valve to finsh the job right install a new Pilot Body with the correct orifice and that will round out a reliable system. Good luck! Tim J&K Heating and Cooling Inc.


How do you fix a burnt valve?

Remove the head and have the valve reseated or replaced.


1991 jeep Cherokee Inline 6 with thermostat on front was overheating so I checked and replaced valve cover seal still overheats after running for more than 10 min?

changing the valve cover gasket will not fix an over heating problem u need to check out the cooling system. Radiator, water pump, hoses, belts


What replaced egr valve on 2001 Dodge Dakota?

Dodge was able to meet the emission requirements with out an EGR valve. Nothing replaced it.


How do you connect a heater control valve on a mark 5 fiesta?

To connect a heater control valve on a mark 5 fiesta all the terminals must be correctly connected. The color coding is used to ensure that the terminals are correctly connected.


What is the valve clearances for a Ford Fiesta 1.1 1993?

inlet 0.20 exhaust 0.30


Where is ecu mk5 fiesta?

The Ford Festiva ECU valve can be found on the firewall in the engine compartment. The valve will be on the drivers side of the engine compartment.


Where is the air bleed valve for the heating system on a 99 Mercury Villager?

This vehicle does not have a bleed valve, it is not needed.


How do you repair a 2000 Mercury Sable after you have replaced the EGR valve and the code still reads EGR valve flow restricted?

DID U Clear the code B 4 U rechecked ?? Did U clean Out the Passage ways where the EGR Valve goes .


Where is the idle speed control valve on a Ford Fiesta 96 model?

its behind the air filter


How do you change the crank case ventilation valve on a BMW 740il?

replaced crank case valve location at valve cover


How do you change the PCV valve on 2000 Blazer?

The PCV valve for a 2000 Blazer is mounted in the top of the valve cover. The valve plugs in and easily replaced.


1998 dodge caravan compressor replaced but the air still isn't cool?

If you did not replace the expansion block valve and the receiver drier then you will need to do this as well..............


You replaced your idle air control valve on your 1998 cavalier but it still idles too high why?

You might need to change your throttle position sensor.


Ford fiesta 1.3 ohv 1998 heater not working. only blowing out cold air have replaced thermostate but still not getting hot air?

THIS IS A COMMON FAULT ON FIESTA'S THERE IS A HEATER CONTROL VALVE INSIDE THE ENGINE BAY JUST BELOW THE CENTRE OF THE WINDSCREEN WHICH HAS THE COOLANT PIPES CONECTED TO IT. IT IS A CHEAP PART TO REPLACE AND IS EASY TO FIT.


What is the valve clearance on a Ford Fiesta 1.3 1994?

inlett is 0.2 mm outlett is 0.3 mm


How do you replace heater control valve on a Ford Fiesta 1999?

its screwed in the right hand side of the engine


What causes a hot water heater to continually run?

The Thermostat and Temp and Press Valve is faulty and needs to be replaced. or the PRV (pressure reducing valve) is dirty and must be replaced