Blown ignition fuse? If not, maybe a broken camshaft/gear?
Follow the upper radiator hose to the engine... you'll want to remove that metal plate that holds the ignition coil to gain access. I suggest replacing the bolts that hold the thermostat housing to the engine, they have broken on me when I replaced my therostat. Had to drill them out when I foolishly reused them.
depends on the make and model it cost me around 350 for a 97 dodge neon It costed me $1300, '00 Accord
because you will do major damage to valves and pistons. they will all need replacing . or at worst engine replacing
how can you start a '89 mercury cougar with a broken ignition switch?
To replace a broken key in a 91 Subaru ignition, you will need to contact a locksmith. The locksmith can cut a key to match your ignition.
If the key is broken off in the ignition of the 96 Crown Victoria it will have to be picked out. If the key is out and broken, a locksmith can use the broken pieces to make a new key or rekey the ignition.
If ignition problems still persist after replacing the neutral safety switch on a 1995 Chevy S10 check the starter. A broken starter will result in a car which will not be able to turn over the engine.
You would know if the computer box does not respond to certain commands or buttons pressed. Car computer boxes are known to break, and they can be fixed or replaced.
how to fix broken concrete drive way be repaired or does it have to be replaced?
sounds like you have a broken ignition wire between ignition switch and fuse box
By replacing it.
Not enough information. In what way is the computer broken?
an incomplete list: broken drive belt/chain; dead battery; broken starter; lack of fuel; lack of ignition (bad coil or disconnected wiring); broken fuel pump; broken oil pump; bad ignition switch/ignition switch failure to read key
Your ignition lock is broken.
Broken ignition wirez...
check neutral safety switch, or it is possible that a bad ignition switch could cause this...or loose or broken wiring!!
A broken computer screen
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
cylinders in lock are bad-spring in ignition is broken and jammed-wrong key?
The Aurora has a VATS ignition and either the contacts in the ignition lock are bad, the wires from the lock to the computer are broken or the VATS chip in your key is dirty or the contacts in the ignition lock is dirty and not making connection with the chip in the key.
You probably dropped the phone at some point and that corner hit the floor. The screen is broken and needs to be replaced. Replacing the entire phone is often cheaper, unfortunately.
Cut wires under the dash or hood or missing fuses and relays?
Usually broken strings are simply replaced.