On the radiator.
On a 2000 Mercury Villager : The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield ( located in the engine compartment )
Because gas fumes are coming out and you're smelling them.
No, there is only one place you can fill (low pressure side), and it is the only place a fill kit will fit on to.
They have a sealed transmission you dont have to fill it. The fluid should be changed around 100,000 and it has to be done by a dealer.
The radiator itself probably holds a half gallon. The car as a whole would hold about 2 gallons.
If you drained the pan, it will take about 4-4 1/2 qts to fill it. If you drained the whole transmission it will take more like 8 or 9.
From the transmission fluid level dip stick. Remove the stick, use a funnel (the tube is very small, about 1/2 inch diameter), fill in the ATF
The same place where you check it, there is a tube that comes up in the right center behind and to the left of the coolant reservoir. It has a small black ball on top. That is your transmission fluid dipstick. It is, unfortunately, not marked in any way. Pull that out and if you need to add fluid put a funnel in that tube and do so.
where is the transmission fill on the mercury tracer
All cars prior to 1995 used Freon R-12. Since then, most have switched to R-134a. The two can not be mixed. That should be marked on or near the fill port.
It is called refrigerant. Take it to a professional to repair the leak as you have one if it is low of refrigerant. He will then fill it up.
Could be you are low on Power Steering Fluid. My 97 Villager seems to need it every 6-7 months. My van will make noises around corners (or hard steering) even if the level is "full". I fill it to the top and all the noises go away (at least for 6-7 months).
To fill your Mercury Outboard Trim boat motor, lower your engine to a 45 degree angle, Make sure your boat is level. Remove fill screw, and add the amount of fluid required to fill.
You should put in enough to fill it up. If you've drained the pan it takes approx. 4 1/2 quarts to refill. If you've drained the whole transmission somehow, it'll take about 9 quarts. Fill it a little at a time to make sure you don't overfill it, as that is not good for it.
Before Mercury, Brandy was used to fill thermometers.
The same place where you check it, there is a tube that comes up in the right center behind and to the left of the coolant reservoir. It has a small black ball on top. That is your transmission fluid dipstick. Pull that out and if you need to add fluid put a funnel in that tube and do so.
Do not add refrigerant. You must completely evacuate the system, then fill it _by_ _weight_ to prevent overcharging. Overcharging can cause leaks and/or compressor failure.
Probably 1-2 lbs
Buy a kit at Wal-Mart or auto parts comes with instructions
Buy refill at local autoparts store and follow instructions. Follow tubes coming from your A/C compressor. There are two refrigerant tubes with test/fill valves, only one will take the fill can screw on filler attachment. FOLLOW DIRECTIONS!!! Car is running w/ A/C on high/max while you fill. Do I have to say this is all very dangerous?
you dont fill it,at midnight the girl and her teacher fill it with oil.
you dont fill it . its electronic power steering