Chevy S-10
Toyota Corolla
VW Jetta

You need step by step directions on how to remove a starter on a 1990 Toyota corolla?

242526

Top Answer
User Avatar
Wiki User
Answered
2007-12-06 19:32:54
2007-12-06 19:32:54

i also need step by step instructions on how to take off old starter and replace new one if any one knows this would be very helpful to me. thanks

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Starter of toyota corolla and matrix is not the same. The best thing you do if you change your starter by yourself is to remove and compare to the new starter.

Same as a 1999. Look for "remove starter on 1999 Corola" post I answered. Same as a 1999. Look for "remove starter on 1999 Corolla" post I answered.

Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.

Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.

How i remove eveporator unit from toyota corolla 2002

how do you remove a center console on a 2001 toyota corolla

remove battery and tray, two, 17mm or 18mm bolts hold starter on. one on top of starter and one on bottom

under the manifold behind the block you might have to remove the airfilter to really see it

it is under the intake manifold. very hard to see and no fun to remove.

how do u remove cv axle driverside 1991 toyota corolla

Remove it and bench test it or bring to auto parts store they can test it for you

How do you remove the heater core on a 1997 Toyata Corolla?

which pully do i remove tension to remove the alternator?

Its behind the motor (if you are facing the car). its a case the size of a rabbit, with 3 bolts. hard to find, harder to remove.

To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.

Remove the negative battery cable. Follow the posative cable down to the starter. remove the wires then the bolts holding it to the engine. Label the wires to make sure they go back where they came from.

The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.

i don't know if the engines are similar enough for me to answer you question but i have a '85 sr5 and when i took off my starter, all i had to do was remove two bolts from behind the starter. you really gotta get down and dirty because they are BACK THERE! hope this helps you out.

The type of the rear seat of the Toyota Corolla will determine how you will remove it. For instance, for a folding seat, all that you will need to do is to lower the seat to gain access.

Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.

it is no suh a thing is fan belt on 2002 corolla

remove the screws which are hard to get to.

You should remove the positive cable from your 1996 Toyota battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

disconnect the battery cables, remove bolts/nuts, remove wire, pull starter off, bingo~! put the new starter in, put the bolts/nuts back on, put the wire back on, hook the battery cables back up, bingo~! fire it up!!!

Remove the plastic panel, remove the bolts, disconnect the wires from the back of the stereo and remove


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.