Daewoo
Daewoo Leganza
Daewoo Nubira
Timing Belts and Chains

You need timing mark for Daewoo?

858687

Top Answer
User Avatar
Wiki User
2006-01-21 05:31:11
2006-01-21 05:31:11

what daewoo. espero, nexia which one there all different.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

look at how to set timing mark for 99 daewoo,explained it there

User Avatar

the timing mark on the crank goes down matches with v notch intake and exhaust both go up but be sure you use the intake mark for and exhaust on that gear.

User Avatar

Line up the timing marks on both camshaft sprockets so that they face each other. And line up the crankshaft pulley mark with the mark on the engine block.

User Avatar

How to replace the timing belt for car daewoo nubira1 -step by step

User Avatar

Is your timing belt broken?

User Avatar

http://wiki.answers.com/Q/What_are_the_cylinder_head_torque_specs_for_daewoo_lanos_98 wwwstlouisparking.com .to Answering "Need timing specs for a 2000 daewoo lanos with the 1.6 dohc engine also need the torque specs for the head too

User Avatar

you dont its preset by the timing belt

User Avatar

what is the timing marks on the camshaft what is the timing marks on the camshaft

User Avatar

There are two timing marks; * On the bottom crankshaft pulley (alternator belt attached) * On the timing belt pulley (you will need to take off the plastic cover) The timing in a Daewoo is set by the timing belt. If you are replacing the timing belt (if it has broken), you need to # Check that cylinder one is at the top of it's upward stroke, the timing mark on the crankshaft pulley should be at top dead centre # Remove the valve cover and check that both the inlet and exhaust valve on cylinder one are closed. You should see the cam lobes both pointing up. Looking at a clock, they would be positioned at the 10 and 2 positions. I have found his car to be very frustrating to set the timing when replacing a broken timing belt. No obvious settings, almost need to pull the engine apart and go back to basics to get the timing right.

User Avatar

do ya need to set timing on cam when changing head gasket on dawoo matiz 800cc

User Avatar

If getting fuel and spark, then need compression and air.

User Avatar

well first you need to get the timing close enough to crank then put a timing light on it and bring timing to top dead center.. which is the second mark on the timing chain cover.. there will be a mark on the harmonic balancer line that mark up with the second mark on the gauge on the timing chain cover.. and should be fine

User Avatar

2.4l dohc balance shaft timing mark, crankshaft sprocket timing mark,oil pump timing mark and camshaft TWO timing marks 2.4l sohc balance shft timing mark, crankshaft timing mark, oil pump timing mark and ONE camshaft timing mark. it is complicated only that everymark must be bang on, if not the pistons will hit the valves and YOU get to rebuild engine.

User Avatar

60,000 Miles is / was recommended by Daewoo. I recommend that you DO NOT exceed this figure.

User Avatar

there will be a timing mark on the harmonic balancer. and a timing tab on the timing chain cover. point your timing light at the timing tab and you should see the timing mark on balancer. if not timing is way out.markstang.

User Avatar

If you google Daewoo Owners club website and go to the Lanos forum. There is a down loadable PDF for a Lanos in the permanent post at the top of the page. The manual covers the 1.3 & 1.5 SOHC and 1.6L DOHC. It has all necessary info. The info you are looking for is on page 175.

User Avatar

I would suspect you need a new timing chain or belt depending on which is installed. A worn belt or chain will jump time.

User Avatar

i need to instal the timing belt on a kia rio 2003 how the mark goes

User Avatar

You need a timing light, hooked to the #1 spark plug, pointed at the timing mark on the main pulley on the front of the engine.

User Avatar

Daewoo Matiz is listed as an interference engine. There is a most likely chance of engine damage ocuring in the event of the timing belt failing

User Avatar

I need timing mark for Toyota paseo


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.