If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
Need to know what year the S-10 is.
you cant does it click when you switch on ignition if not change it.
my granddaughter has a 1997 GEO prism LSI. i need to know how to remove the ignition switch
The ignition switch is one unit and you replace the entire thing. Do not confuse the ignition switch with the key lock tumbler. They are two different things.
It will not engage and send current to the starter. You will not hear a click or anything else if the ignition switch is bad. With your headlights on when you turn the ignition if the lights dim is it not the ignition switch but more than likely a bad starter. If the lights do not dim it is more than likely the ignition switch.
If the switch fails, however, you won't be able to start your vehicle
It sends a power to the starter relay/solenoid to engauge the starter. Know that the ignition switch is not what you put the key in and turn. That is the lock assembly. The ignition switch is located lower down on the steering column.
You know your ignition switch has gone out when you turn the key and there is no click or any noise at all. If there is a click or other audible noise it is probably the spark plug or something of that sort.
I am working on changing my 93 Explorer ignition switch now. As soon as I figure it out I will let you know. :-) Still working on it.
i do not know go to a car stereo install ... store
you need to be more specific. i am going to assume you want to know in what position is the ignition switch in lock. usually it is 2 positions back from "run" but it is in whichever position the key comes out of the ignition.
the steering wheel will lock and the key will come out, unless of course the ignition cylinder is broken
I would assume you could in any car. I know you can in motorcycles, boats, American cars, etc. Just find the part and a repair manuel.
i know, burnt it.
if the starter is not spinning and the truck motor is running
I don't know, ask someone outs....
I don't know thats way I ask
AnswerSounds like a bad ignition switch.I changed the ignition switch and there was no changeCheck the neutral safety / transmission range sensor next.I know, it doesn't seem it could cause electrical gremlins, but...
You need to remove the dash panel underneath the steering column. You will find the switch attached to the left side of the column with two 5/16" or 8mm screws. If you are sure it is the switch, you can go ahead and buy one so you know what it looks like, and know what to look for under the dash.
Its the ignition switch change it and that will stop the problem
Need to know the firing order for a 1989 Olds 88 and the corresponding numbers on the ignition coil pack
please need to know how to unlock ignition switch on my 96 chev college study have no money
ignition is sticking and let me guess it was rolling try a parkin brake I am having the same problem. I don't know the answer yet, but I know that the response above is insulting. I can tell you that it, in my case and possibly yours, is not the key switch, the ignition switch, the solenoid, or the voltage regulator.