answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-12-27 00:30:40

The check engine light means that the computer has a problem code that you need to read. Use a diagnostic code reader for your vehicle. Your Chevrolet should be OBD2 compliant, meaning that you need an OBD2 code scanner.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

Where is the crank position sensor on a 1995 Monte Carlo located?

The crankshaft position sensor for the 1995 Monte Carlo is located on the front of the engine. It is just to the right of where the crankshaft comes out of the engine.


Can you see a Picture of a 2002 Monte Carlo 3.8 engine?

where is the mass air flow sensor located on a 2001 chev Monte Carlo


Where is outside temperature sensor on a 2006 Monte Carlo?

Where is hood open sensor on 2006 Monte Carlo


Knock sensor location for Chevrolet Monte Carlo 3.1 1997?

Back of the engine block, underneath the coilpack.


Is it possible to put a rx8 engine into a 96 Monte Carlo?

Anything is possible if you have enough time and money, but the practical answer would be no.


Where is the knock sensor in a 2000 Monte Carlo SS?

The knock sensor is located on the front (radiator) side of the engine block above the oil filter The knock sensor is located on the front (radiator) side of the engine block above the oil filter


How do you install the knock sensor in a 2000 Monte Carlo?

Where is the knock sensor on a 2000 monti carlo ss 3.8l


Where is the crankshaft position sensor on a 2003 Monte Carlo SS?

where is the crankshaft position sensor on a 2003 monte carlo


Where is the vapor pressure sensor MAP on a 1997 Monte Carlo LS 3.1?

the map sensor should be visable on the top of the engine, right behind the intake manifold.


Where is temp sensor on 97 Monte Carlo z34?

Just next where the radiator hose goes in to the engine. (Driver side)


Wheres the O2 sensor located on a 1987 Monte Carlo ls 4.3 engine?

its on the passenger side engine manifold towards the collertor. its a one wire unheated connection. the wire my break out of the sensor so be careful.


Where is the up-stream O2 sensor located on a 97 Monte Carlo Z34?

in the exhaust pipe between the engine and the cat


How do you fix gas gauge stays on full in your 1997 Monte Carlo?

The fuel sensor is in the gas tank and probably needs replaced, the tank will have to come out to fix it.


Where is the MAP sensor on a 1996 Chevy Monte Carlo DOC 3.4 engine?

The Manifold Absolute Pressure (MAP) sensor is located on the firewall side of the upper intake manifold plenum


Where is speed sensor located on 1984 Monte Carlo?

The speed sensor on a 1984 Monte Carlo is located on the output shaft. The speed sensor is typically driven by the gear of the vehicle.


What is the sensor in the gooseneck on 1986 Monte Carlo with a 305?

If it has vacuum lines attached to it, it is probably a thermoswitch that controls the vacuum to the egr valve. If it has an electrical connection it is probably a engine coolant temp sensor.


Could replacing an engine ruin your transmission. I just got the motor replaced in my 2001 Monte Carlo. About 50 miles later the trans started slipping and speedometer Acting funny. Is it related?

Take it back to whoever did the engine job. They may have not connected the speed sensor connection properly.


How to remove engine 2001 Monte Carlo?

how to remove the engine of the 2001 monte carlo step by step


2004 Monte Carlo overheats radiator replaced cooling sensor replaced cooling system flushed fans replaced thermostat replaced any suggestions on fixing problem?

you might want to check for a blown head gasket or a cracked head or block. espically if it loosing water out of the radiator with out leaking on the ground.


Where is the speed sensor on your 1997 Monte Carlo?

The Vehicle Speed Sensor is located on the transmission.jd


Where is 2003 outside temperature sensor?

Where is outside temperature sensor 2003 Monte Carlo SS


How do you Install a Knock Sensor on a Monte Carlo?

yes next to tjhe oil filter on a 1997 monte carlo


How do you change o2 sensor on Monte Carlo?

Depending on the year of the Monte Carlo the 02 sensor could be installed in several places on the exhaust. The 02 sensor screws in. You may need a special socket to remove it, just unscrew the sensor and screw the new one in.


Where is the camshaft position sensor on a 1997 Monte Carlo?

Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.


Where is the pcv valve located on a 00 Monte Carlo?

On the passenger side of the engine just ahead of the alternator, under the edge of the plastic engine cover there is a sensor with a plug and wires coming out of it, it says sensor pressure on it.That entire unit twists off and the pcv valve is under it


Still have questions?