I'm considering swapping the engine in my 98 Jeep Wrangler (a 2.5l 4) with the 4.0l 6. I haven't done so yet, but I came across a website of someone else that has: http://www.jeepaholics.com/tech/25to40/25to40.htm That may help you out, or at least give you a little more to go on. Sorry, I realized I didn't make it clear: My jeep is a 98, but the jeep on the above website is a 94.
To edit original question....Jeep Wrangler 2005 manual transmission
Yo have to remove the transmission.
Yes, it was the exact same engine used in the wrangler in 1992, although if you didn't already have the 4.0 you will need an adapter to the transmission, or replace that too with an ax15.
Transmission seals? front yes, rear no. Engine seals, yes.
Replace water pump and gasket
Drop transmission pan Clean Replace filter and pan gasket Re-fill DO NOT OVERFILL
Converting a manual transmission to automatic transmission is not possible but you can replace a manual transmission to an automativ transmission . That is also an expensive deal.
The water pump does not have a specified life span. The time to replace it is when it is leaking or noisy.
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
how to replace the slave cylinder on a 1993 jeep wrangler
No. The entire driveline would need to be replaced. You could if you change the engine, trans, wiring , computer, radiator,.......
you jet some glass that fits a 1995 jeep wrangler
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
how do you replace a blade wiper motor on a jeep wrangler 2006
possible cable Remove from transmission and check if in one piece - if not remove speedometer head and replace cable to transmission and head
simple enough. there are 2 plugs on the trans, one on the bottom to drain, and one on the side to fill. Drain it out, replace the plug, remove the side plug and pump the appropriate manual transmission fluid in until it starts to dribble out of the hole and then replace the plug. Done!
how to replace 97 Lexus ES300 transmission
You have to remove the transmission to replace the torque converter.You have to remove the transmission to replace the torque converter.
If you tear a hole in your transmission pan shut your vehicle down as quickly as possible and have it towed home. You can get a new transmission pan and some new fluid for far less than it costs to rebuild/replace your transmission.
You will have to replace it.