0
Your 1987 accura integra starts up ok and runs fine until you kill the engine after warm up then you can not start up engine turns over ok?
Wiki User
∙ 2008-01-22 05:11:22
Change the Coolant temp.Sensor.
Wiki User
∙ 2008-01-22 05:11:22
Add your answer:
Earn +20 pts
Warm engine won't start?
why won't 1992 Accura Integra RS start in warm weather
Why does temperature in accura integra change from normal to very hot?
your coolant is low.......this happens when you are idle and then once you start moving it goes down......fill your coolant to the top and itl fix this problem
No start or click noise on 2000 accura tl 3?
the first thing that come to mind are a bad engine ground and a broken solenoid -Jon
What causes the 15 Amp ignition fuse to keep blowing once the engine is turned on in a 1997 Acura Integra?
WHY MY ECU 15AMP FUSE BLOWS EVERYTIME I START MY 97 ACURA INTEGRA
Why does my Engine starts then stalls after 15 sec?
my suburban wont start
Time when trying to start the car engine turns but will not start turn key off then on again it starts right up?
Time when trying to start the car engine trns butwill not start turn key off then onagain it starts right up
Why would a 91 integra have power in the on position but no power when you go to start it?
no power in the injectors 95 integra
What is the problem when engine 4jg2 start after time it stop?
When the engine 4jg2 starts then its stops it is due to a mechanical failure.
How does a jet engine start?
you blow air into it to start the blades moving and then you give fuel to the engines and it starts up
1997 Chevrolet Malibu doesn't start but then if relay is wiggled by engine under hood car starts can this be fixed?
1997 chev Malibu doesn't start but then if relay is wiggled by engine under hood car starts can this be fixed
Dodge Colt 1989 with a Mitsubishi 1.5 engine does not start when warm?
It starts better when its warm!
Why would my car stall and won't start?
If it starts good when the engine is cold but starts hard when engine is warm and hesitates, check or change the water temp sending unit. Hope this helps.
