answersLogoWhite

0


Best Answer

Ignition switch worn out and needs to be replaced? After 20 years

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 1987 ford ranger signal lights and heaterair fan blower only come on when the ignition switch is placed in a certain position Now they don't come on at all in any ignition position Why?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix heaterair conditioner blower fan for a 1992 Mitsubishi Galant with no power to the blower or heater relay?

check fuses,see if ones blown check power at blower, don't forget the fan switch ,there famous for going out.


Why does the blower motor not work without pushing or pulling on the ignition key and having the key in just a certain position on a 2005 dodge ram diesel?

Your ignition switch has failed. There is a good chance that the wiring plug for the switch has melted slightly due to a blower motor that is pulling too many amps. You will have to replace the switch, plug, and blower motor.


Blower motor relay switch Honda civic?

The blower motor relay switch in the Honda Civic is located at the center of the engine closest to the firewall. The relay is engaged when the ignition is turned to the on position.


Can you use a tester for GBI 22v leaf blower to check a spark on ignition?

can i use a tester for GBI 22v leaf blower to see their a spark on ignition on blower


Blower motor runs with ignition off?

probablly a bad ignition switch or blower motor not sure on that should run without power


What cause the air conditional and heat blower fan on a 1996 buick lesabra to continue to run when you have the car ignition switch in the off position?

bad relay


The blower motor of a air handler unit is considered an ignition source?

Yes. The blower motor of an air handler unit can be considered as an ignition source.


Is the blower motor of an air handling unit is considered an ignition source?

Yes. The blower motor of an air handling unit can be considered as an ignition source.


How do you replace the heaterair blower motor on a 83 gmc 2500 vandura?

On my 1989 you first remove the engine coolant reservoir as the blower motor is right behind it. Disconnect the two wires, remove about 10-12 screws around the motor. Then twist, turn, and wiggle the motor out. It's a pretty tight fit so it won't be the easiest thing to get out.


1997 Thunderbird LX Blower always runs when ignition is on.?

It is supposed to run on the lowest setting when the ignition is on.


Why does the blower motor only work on high even when the ignition is off?

it's a problem with the blower motor resistor,


2004 silverado heater blower only works on position 5.?

Bad blower resistor?