my trans shifts late it dosent slipp shifts hard to get into 1st and 2nd after that she goes right into 3rd then 4th normally i was wondering if there is a shift sensor to tell the trans when to shift
internal trans problem need new trans sorry
the kick down cable shifts the 700r4 trans
really? what drive shaft. its a shift tube for the trans. trans is in the rear of the car. its called a trans axle. trans shifts the cv joints which turns the wheels. so you never have to take down the shift tube for no reason theirs a long steel rod inside that tube. that comes from your shifter to the trans.
Because that's all it can shift. It starts in first. The first shift puts the car in second, and the second shift puts it in third.
Some Chrysler vans have a software update for the trans computer available at the dealer for harsh shifts. Other than that there could be an internal problem.
That's how the AUTO shifts. Its normal if it takes a little longer.
it may be the slave cylinder or clutch master cylinder
Loose hold down clamp or broken shift cable.
Have your trans shop check your wiring harness. Sounds like an electronic prob.to me.
auto or man? auto change trans filter and add new trans fluid I'd use lucis trans fluid. cable could be streached
the trans will still shift into gear with a bad clutch you will find tho, sometimes this will not happen. usaully it is NOT indicative of other problems.
If the transmission on a 1999 Chevy 4x4 will not shift into high gear, there could be a problem with the shift solenoid. There could also be a problem with a broken belt inside the transmission.
Is it an automatic? Time for a new transmission... If a stick and 1st, 3rd, 5th are ok, then you have a possible shift cable problem. You should be able to see them on top of the trans. If everthing is moving properly the trans has an internal problem.
A Shift control soleniod for a exploer is in the transmission and controls the shift pressures for the trans. When bad you will feel a bang into gears. Very common problem on an exploer.
THIS IS A COMMON PROBLEM ON THE GM TRANS WHICH IS A BROKEN 1-2 ACCUMULATOR SPRING
If the problem is that the shifter will not move you need to check the shift cable. If the shifter moves, but the trans doesn't shift; you need to check the fluid level and , the system for trouble codes.
It may be low on fluid. If not then the bands inside the transmission are bad or gone.
If it's automatic, then possibly low on fluid, trans solenoid problem, dirty trans filter. If manual, possibly clutch, throwout bearing, haydraulics etc.
You need to have the trans computer checked for trouble codes. The car will not shift out of 2nd when the system detects a problem and sets a code.
depends, what kind of trans is if, if its a 3speed then that's as far as it should go. Have the engine and trans computers checked for trouble codes. The 4 speed will not shift when the computer detects a problem and sets a code.
The TCM (trans computer) has detected a problem and set a code. This causes the trans to go into safe mode and not shift. Have it checked for codes.
if you have an aw4 trans you should try cleaning your trans range switch there are instructions and pics on line it might fix you problem new trans range switch is around 200+$ all you need to clean and fix it is electrical cleaner and dielectric grease about 12$ and a little time
Check transmission fluid level if full you have an internal trans. problem Check transmission fluid level if full you have an internal trans. problem
If it is a transmission problem- First step would be to change trans. fluid and filter If it is a transmission problem- First step would be to change trans. fluid and filter