have starter motor checked. Ford starters will run a battery down when swithed off if they are worn out.also check ignition switch Check the fuel pump relay. It may be sticking.
Right in front of the battery, between the battery and radiator.
Your battery isn't being charged or accepting a charge
The battery warning light illuminates when the battery isn't being charged , get it checked out to find the problem and then repair.
install ignition 2002 ford ranger directions
No , it has four fuel injectors but it has Fords twin plug ignition system so it has eight spark plugs
Check the voltage regulator mounted to the fender
Yes. The 3.0 block, heads, intake manifold and other main components remained the same for about a 10 year period. The only changes are in the ignition, and emissions systems, not fuel injection.
To replace injectors on a 1999 Ranger 3.0, first eliminate the fuel pressure. Then remove the rails as well as the fuel lines. Finally, remove the o-rings and replace injectors with new.?æ
Sounds like either loose or corroded battery terminal or bad fuseable like
First ensure O2 sensor is working properly, replace if wires look melted. Then, turn ignition to acc. disconect Battery. Turn off ignition re connect battery & eng light will be off
The most common reason for your 1999 Ford Ranger pickup truck not to start is a battery that needs to be charged. Charge the battery for a minimum of 15 minutes.
If the truck has distributerless ignition,disconnect battery for a few minutes,reconnect battery & drive the truck.The computer should reset timing within 10 miles.
The 1995 Ford Ranger ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
At this time of year, the most likely cause of your problem is a flat or chilled battery. Battery temperature is critical to the electrolytic process, that your battery uses to deliver power to your vehicle's systems. Generally, a warm battery can deliver more power, than a cold one.
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
ABSOLUTELY ! disconnect your negative battery cable , then your positive battery cable , and wait at least 2 minutes for the back up power supply to drain
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
battery cable connection , dead battery
This makes no sense. What is your question?
Nope- electronic ignition.
The ignition wire for the 2001 Ford Ranger is yellow. This is the 12 volt constant wire. Other wires in the harness are red and blue.
No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )
It is secured with screws at the fenderwell.
Will it even crank? If it won't, you have an ignition switch or lock cylinder going bad. If it does crank, just not running, then check to make sure fuel pressure is good and that the ignition coil is good. When exactly will it not start?