Align the shift indicator orreplace it. Your problem is strictly column mechanical.
i have a 92 s-10 blazer and it has no reverse Andy ideas?. it will go in to drive and shift in to all the gears..but will no go into reverse? can u help me
It's inside the transmission (between the engine and the gears).
the transmission is smoked needs to be taken out and inspecked or there is a LINKAGE PROBLEM GOOD LUCK JOEY
The input sunshell splines have stripped or the hub has broken off. This will give you 1st + 3rd gears only with no reverse, 2nd, or 4th gear.
Reverse, Drive, Low gears
your problem is the transmission. you need to replace the transmission
It should have two, one on each side of the spider gears between it and the differental carrier. Normally .031 to .062" in thickness.
If this is an automatic transmission, more than likely the transmission is on it's way to the junkyard. Usually failing transmissions lose reverse first, then the higher forward gears - last will be the lowest forward gears.
I would doubt it. The gears are usually dimensionally different in the front and rear axles. NO!
I the Blazer will run then the timing can be checked with a timing light. If not, the there are timing marks on the timing gears that will have to be checked to see if the timing jumped.
It does not have a timing belt, That engine has a timing chain and gears and they normally last the life of the engine.
reverse drum inside of trans is stripped out the fix is teardown unit and replace with abeast drum from transtar