answersLogoWhite

0


Best Answer
Copy

ok when you did the 10 mins did you dissconnect batt???? you should if you havent it will summtimes reset the comp my fix on my 97 G AM was replacing the ignition cylinder with "passlock" in my case might use different system in 2001. Cost 150ish at a gm parts supplier.

2009-01-26 17:24:27
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Is Amy-leigh hickman going out with anyone?

she's not going out with anyone at the minute.


Anyone try the Facebook app One Minute Mogul?

no


Has anyone lost weight on the 10 minute trainer by tony horton?

No not likely.


How many words can Eminem type in a minute?

How would anyone know that and why do I care


Turns over won't start 2000 grand am?

If your security light is flashing, then you have had what is referred to as a "bad timing cycle" with your Passlok security system. Turn the key to the ON position, and wait until the security light stops flashing - This takes exactly 10 minutes.If the security light WAS flashing, then the 10-minute trick is only a temporary fix - You will need to have your ignition switch replaced.


How do you change the date and time on your 2006 Honda accord?

try holding the hour/minute buttons until it starts flashing. then click them again w/ radio dials


Who can multiply 6 times of 365 within 1 minute?

Anyone with a calculator - 2,190


Does anyone have that 30 minute love song mix from the 90s?

90 s in min


Your projection big screen TV keeps flashing black The picture comes up but starts flashing black The audio is unaffected What is wrong?

This happened to me as well. It started after a breaker blew. The way I fixed it was to disconnect the tv from a power source for about a minute, then plugged it back in. Hope that helps!


How do you change the time on dashboard clock for Nissan almera?

if it is a 2001 model - there are normally 2 black buttons- one at either side the display. Press and hold the button on the left hand-side until the hour on the clock starts flashing, then keep pressing the left hand button to your desired hour. Press the right hand button until the minutes starts flashing and press the LHS button to your desired minute. To finish either press the RHS button once again or leave until the minute flashing stops


Why does the colon of an alarm clock flash?

Because digital clocks don't have second hands, the flashing colons imitate it instead. Count how many there are in 1 minute, you should get 60.


What is the basic operation of 220 volts flashing lamp?

Basically the circuit to the lamp opens and closes in a specific amount of times per minute. In some models this can be varied with a control circuit that allows the operator to set how many times the lamp is to flash per minute.


Is 72 beats per minute normal for a seventy five year old woman?

70 beats per minute is a very healthy heart rate for anyone.


Has anyone won level 10 of 'Minute To Win It'?

Not yet, as of Feb 9th, 2011.


In the distance you notice a flashing light you count the number of flashes and find that it is flashing 60 times in one minute what is the frequency?

Frequency is measured by hertz, or Hz. 1 Hz is a frequency of one cycle per second, and as such a frequency of 60 flashes per second would yield 60 Hz.


Does anyone have a funny persuasive speech topic that is broad enough to do an 8 minute speech?

that's not the answer dimwit


What information does technology give?

more than anyone could ever explain we get more technology every minute


Does anyone want to buy a white touch screen slider phone?

Sure. There is a sucker born every minute!


Why would the blue temperature light in a '99 VW Beetle start flashing but stop after turning the car off for a minute and turning it back on?

Could be that the coolant level is a bit low and the flashing light is telling you this. The level will drop when the fluid is running thru the motor. When you turn the car off the level rises back to nominal level. Dan


How do you change the minutes on the 2005 Durango clock?

Push and hold the time button until the hour starts flashing. Let go of the time button and turn the tune/audio button to adjust the hour. Then push the tune/audio button, the minute will start flashing. Adjust it the same way as the hour then push tune/audio button to save settings.


Can you give a 2 minute speech on animal cruelty?

Anyone can give a 2 minute speech on animal cruelty. The speech could be about the uses of fur, animal testing, and the poaching of animals for their meat, skin, and fur.


Does anyone have info on wild blackberries how to cultivate?

The minute you cultivate them they cease to be wild. The best way is to buy some hybrids from a nursery.


What does a minute your here a minute your gone mean?

One minute you're here, the next minute you're gone. It refers to the frequently abrupt nature of death. It means that no one has a lock on this life. Jesus said, " "My time has not yet come, but your time is always here. " (John 7:6, ESV) Anyone can die at any time. And death can, and frequently does, come suddenly. One minute you're here, the next you're gone - dead.


In the show Supernatural season 4 Episode 19 at the minute 12.02 starts a soundtrack. Does anyone know the name of it?

In the show, Supernatural season 4 Episode 19, at the minute 12.02 starts a soundtrack; the name of the soundtrack is Come on.


How to adjust the time of a pixel DD101-2 odm watch?

Press the function key to enter the time mode. Press and hold the function key for 3 seconds to enter the setting mode. While the "hour" digits are flashing, press the function key to set the hour (each press moves forward 1 hour). When the hour is set, press on the function key for 3 seconds until the "minute" digits start flashing. Press the function key to set the minutes. When the minute is set, press on the function key for 3 seconds until the "month" digits start flashing. Press the function key to set the month. When the month is set, press on the function key for 3 seconds until the "day" digits start flashing. Press the function key to set the day. Release the function key for 30 seconds to exit the setting mode.