Reset the inertia switch in the passenger kick panel. The button is facing down and may not be visible. It will click when reset.
It sounds like no spark on your plugs check the power going to your coil if you have that then it could be the ignition module under the rotor,assuming you do have gas in it :)
A: A stepper motor does it not start and spins but rather move to the next position according to the polarity of the power applied
you start a power point by going to Microsoft Office if you have it.
The truck will have lower oil pressure when idling, and when the crankshaft spins faster, the oil pump spins faster, creating more oil pressure. Much more info is needed. Start by checking if the truck has oil. It should take 5 quarts of 5w30. The next step is testing the oil pump.
haca
Fuel pressure should be around 40. If the injectors are not getting power it will not start. Start with a crank sensor first.
what does it do? see discussion board there is no power to the fuel pump i just changed the fuel pump and power is going to it there no power going to the coils why is that
what would cause a no start condition when engine spins in a 95 taurus sho 3.2l
digit
That would be the starter.
hard start ups. wont pick up speed.
Noisy fuel pump, stalling, or engine will not start and you have no fuel pressure.