Just went through the same problem car was sputtering gas milage went way down was running very rough it felt like it was going to stall everytime I came to a stop,I changed everything you did still the same,then I changer the O2 SENSOR the top one by the manifold car is running great now sensor is about 70-80 dollars very easy to change just remove heat shield and it's very to acess
You go to a mechanic!
usually it will come on when the oil needs to be changed or when something on your car is malfunctioning. take the car to a mechanic who has a diagnostics computer to find out the cause of your problem
An engine light means the cars computer has detected a problem. A parts store sells a tester for around $100 to tell you what the code is. A mechanic shop should also be able to tell you. The code will tell you exactly what component or system is defective.
Have vehicle scanned to determine the problem-- Could be 1 cylinder not firing due to bad ignition coil or more serious problem
Sputtering and hesitation in a Mazda MX6 could be caused by several issues, such as dirty fuel injectors, a clogged air filter, a faulty spark plug or ignition coil, or a problem with the fuel pump or fuel filter. It is best to have a mechanic diagnose the specific cause by performing a thorough inspection and running diagnostic tests.
It is on because the computer has detected a problem with the emissions system. Take it to a trusted mechanic for a scan and diagnostic of the problem.
There are a couple of reasons why a Jeep Wrangler may be sputtering. There could be a problem with the sensors or a problem with the fuel lines.
Laptops allow people to bring the computer to the problem, instead of the problem to the computer. This allows much greater use of computers to solve the problems of society.
The error code 68, on a 1993 Mazda, is a reference to a computer problem. The problem should be addressed by a certified mechanic.
consult the trouble shooting section of your repair manual
depend serveral things , you have to tell more of the problem
Your pressure washer sounds as if it has an air lock. You need to run your pressure washer, full blast, and aim it towards the sky until the sputtering stops. That should take care of this problem.