You must press 5 second on your remote desalarm
Just had that happen yesterday! Try putting your key in the door and turning it back and forth a couple of times. That should restart it! :)
Fix the problem and the light will reset itself after a certain number of drive cycles.
When you turn the key off and lock the doors, there will be a red light on the top of the dash that flashes while the alarm arms.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Reprogrammed, no. The code cleared to turn off a check engine light, yes.
The check engine light on a 2005 Jeep Grand Cherokee looks like this... Here is a link Check Engine Light It looks like a little yellow engine.
Fix the problem and the light will reset itself after a certain number of drive cycles.
it means somthing is wrong with your abs system more then likely a wheel speed sensor
How do you install passenger tail light kit for a 2004 grand cherokee?
Motion detector alarm systems operate by using light sources. A beam of light is aimed at the light sensor and anyone who passes causes the sensor to register.
When you turn the key off and lock the doors, there will be a red light on the top of the dash that flashes while the alarm arms.
Put the key in the drivers door lock and turn it to unlock - it will turn alarm off while sounding OR will turn alarm off as well as unlock door - just watch the red alarm light flashing it will go out.
try opening your door than hitting the alarm two or three times. sometimes when your light stay lit it means that your alarm is working it's just on silent mode meaning when you arm it your horn want beep
Yes.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Abs is difficult to diagnose. it is probably a bad wheel speed sensor.
Reprogrammed, no. The code cleared to turn off a check engine light, yes.
Interior lights are controlled by the overhead console, Hit "Menu" until you reach the interior light delay, then press "STEP" to change.