Have you checked if its a belt or a chain?
left hand thread i had to take mine off on my 1993 2.4 frontera hope this helps
On a Vauxhall Cavalier Ecotec 2.0L, the timing marks are located on the front of the crank pulley. It is marked under the cam.
Loosen the tensioner pulley. The alternator belt will come loose. Remove the alternator belt. Put the new alternator belt on and tighten the tensioner pulley.
Remove bolt, and use a harmonic puller to remove pulley.
Help in setting a cam belt pulley
The tension pulley should have a bolt that holds it on, allowing you to replace the unit.
You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.
Remove the old, damaged idler pulley and replace it with a new one.
replace the pump
replace 1996 nissan 200sx se 1.6 tension pulley
my husband just did so. the pulley is part of the air condition compressor, so you have to replace the whole part that's connected to the pulley, you can'tjust replace the pulley it self, and going to the junk yard for these partsis very cheap and the way to go.
Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing). Reverse to install Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing).
Bottom left of engine near the pulley wheel
Call the parts store. They will be able to tell you if the pulley is available separately or not.
what pulley/ there are only about 7 or so on a vehicle. water pump, alternator, ac, power steering pulley
That pulley has a bearing on the inside of it that has gone bad. Replace the pulley with a new 1
Try to replace only bearing #6203 2Z inside of pulley.
Remove air box, pulley is located just under attached to engine block. Should remove bolts take off belt, and replace pulley and belt.
around the crank pulley them over to the idler pulley then arounmd a/c pulley up to the alt. pulley then to the p/s pulley to the tentioner. there wasnt that easy
purchase a pulley remover and installer tool, then write baack when you have it.
Replace tentioner pully on 2.8 multiport
When it goes bad
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
To change a Vauxhall Corsa timing change you need to first remove the rocker cover, the alternator tensioner, heat shield, water pump, engine mount, and crankshaft pulley. Now that you have found the timing change, unscrew the timing chain guides, remove old chain, and replace with new chain.