Overheating can cause some serious engine problems. Once the check engine light is on you need to use an engine diagnostic code reader to find out what's wrong. You can borrow, rent or buy the code scanner from most auto parts retailers.
Every 90,000 miles per Mazda
at the library
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
No , it is not an interference engine
yes, protege 5 is 01-03 yr you can fit the protege same years for i direct swap and if you want an older engine youll nee the ecu and matching harness.
yes all the dx lx and es proteges have the same engine. atleast that year does
No , the 1.8 liter 4 cylinder in a 1999 Mazda Protege is not an interference engine
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
The Mazda Protege fuel reset button can be found on the firewall in the engine compartment. The reset button will be in the middle of the firewall.
The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
A diagram of a 2000 Mazda Protege engine is available through service repair manuals. The manuals are available in either print or PDF form.
A 2001 Mazda Protege uses standard 10w-30 motor oil. This provides a good balance of viscosity and protection for the engine.
It is the center to the right of the engine...
Click the link.
Yes, you can if the trans is disconnected.
If u have the same 1.8 or 1.6 in them u should be able to.
Were is the egr on a 1992 mazda protege
where is the thermostat on a 1999 mazda protege?
exhaust gas recirculation flow insuficient
crawl under your car and look in the rear of the engine.
behind the engine on the firewall
Where is the thermostat location on mazda protege 2003?
Where is the igniyion coil on a2002 mazda protege