0
Your ford contour transmissions seem to be slipping when it is in Drive It has good traction ing low or second gear - added a quart of fluid and level is ok Also the check engine light is on.?
Wiki User
∙ 15y ago
get your codes read at local auto store and see if trans codes are there.there are a couple of sensors that could effect the trans dramatically.the speed sensor and the shift position sensor.also make sure sensor wiring is ok.good luck
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can a transmission on a 1998 ford contour with a four cylinder engine fit on a 1998 ford contour with a v6 engine?
In short, the answer is "No." The longer version is that while they will bolt up, the transmissions for the V6 are made with different ratios than the transmissions for the 4-cylinders. The computers for the engines are programmed for the "right" transmissions, and I seriously doubt the driveability would be acceptable.
What causes manual transmissions to have no power when shifting?
If the clutch is not slipping, I would say the transmission is fine, the engine may be the reason for the lack of power.
What is drive wheel?
All wheel drive is automatic:no driver interaction is needed.The system senses a loss of traction and redirects available engine torque to the wheels that have the most traction and away from the wheels that are slipping.
What is all-wheel drive?
All wheel drive is automatic:no driver interaction is needed.The system senses a loss of traction and redirects available engine torque to the wheels that have the most traction and away from the wheels that are slipping.
When was Trevor the Traction Engine created?
Trevor the Traction Engine was created in 1954.
Why is the check engine light on along with the TC symbol and a message that says engine power reduced?
"TC" symbol means "traction control", in other words it's trying to keep you from slipping when you try to go. If that light is constantly on, and the check engine light is on, it's PROBABLY telling you that there is something wrong with the traction control system, perhaps a faulty or disconnected wheel sensor.
When was the first traction engine introduced?
The first traction engine was introduced in the 1850s. The first successful traction engine was developed after a series of experiments by Thomas Aveling in 1859.
What is the ets button on a 1996 Pontiac grand am gt?
ets is enhanced traction system ... pretty much, it prevents the wheels from slipping and increase traction (obviously) but, its wicked fun to turn off because the tires spin out essentially, the way this works is that the system reduces engine output ... so there you go
When did William Fletcher - steam traction engine designer - die?
William Fletcher - steam traction engine designer - died in 1918.
When was William Fletcher - steam traction engine designer - born?
William Fletcher - steam traction engine designer - was born in 1848.
Is the 1997 Ford Contour engine a interference engine?
The engine is a non-interference engine.
Will the engine from a 98 contour svt fit the transmission of a 98 contour se?
check this link out
