Wiki User
∙ 2006-03-30 20:07:41If you just installed a stereo system or any other "electrical" device make sure no wires were cross and that all connections are as they should be. This could be tripping you fuse. Also, Check your fuzes and their connections also. Hope this helps.
Wiki User
∙ 2006-03-30 20:07:41Signal lights staying on withot flashing indicates either front or rear signal bulb not working on the Audi
The turn signal relay and hazard relay may need to be replaced, see your dealer You may have a short.
how do u change front signal lights for corvette 1999
The front or rear turn signal flasher bulb may be burned out and needs to be replaced. The turn signal flasher my be defective and should be replaced. The hazzard lights have a flasher unit of their own. These are found up in under the dash in the steering column area.
Either the front or rear bulb is burnt out.
For the front or rear turn signal?
Not as front signals.
if the front signal is working and the back doesn't, the light is probably blown.
it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch
If all the running lights (front & back) are not working I'd start by checking the fuses then onto the headlight switch
Typically, it is a light bulb. Turn that indicator on and check to see if either the front or back light is not working. Some newer cars have turn lights on the front side as well. Compare to the working side to find all the lights that are used. Good luck
Are both lights coming on and staying on? sometimes when a light is out on the front or rear the lights just come on and will not blink.