Pontiac
Grand Am GT

Your signal lights are not working on your 1994 Pontiac gran am?

123

Top Answer
User Avatar
Wiki User
Answered
2014-10-06 22:33:32
2014-10-06 22:33:32

When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The fuse probably blew that controls the dashboard lights.

The 1994 SSEI is on the overhead counsel.

Have you checked your fuses?......if its not a fuse it could be a ground or burned wire. maybe even the brain......

There are two...one that sends a signal to the gauge and one that sends a signal to the computer.

There's a turn signal or running light out on that side, either front or rear. Turn on signal, get out and look. If both turn signals are working, chances are its the running light.

Typically, it is a light bulb. Turn that indicator on and check to see if either the front or back light is not working. Some newer cars have turn lights on the front side as well. Compare to the working side to find all the lights that are used. Good luck

Where is the 1994 JEEP grand cherokee Daytime Running Lamps Lights Module? Lights are working but the running lights and dash board lights are out.

Unscrew nuts in the trunk were the lights are.

A blown fuse would cause the hazard lights not to work on the 1994 Ford F150. It could also be blown bulbs causing the lights not to work.

Most of the cars now have composite lights and the lights have to be revomed to replace the bulbs.

check the connection there was a corrosion in the connection of my firebird that was stoping all of the bulbs to work and check the ground on the bulbs if that don't work i would have to say start tracing the wires under the carpet for bad wires but dielectric grese is the tail lights best freind after you get them working. Good luck

PULL THE TURN SIGNAL LEVER TOWARD THE DRIVER. THAT CHANGES FROM LOW TO HIGH BEAM

The 1994 Pontiac 3.8L V6 has 170 hp.

Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.

where can you find a diagram of 1994 pontiac grand am motor?

Try the fuses first then see if you have power to the fan and lights. Get a test light or multimeter.it could be the bulbs and fan. the switch. make sure you have power at the fuse box. then the switch. check the wires.check for loose grounds. Good Luck

I laid down on the garage floor and reached up through the bumper, not an easy task but it worked.

Take the interior panel off that is located below the steering wheel, held in place with two screws.

I would check the parking lights,turn signals and side lights front and back.Its got to be one of them. It either don't blink,or don't come on at all or might have a short in the bulb itself. I own a Pontiac sunbird 1994 and if the problem is inside the cab more than likely I would say that its got to do with the signal selector and the relay switching in the steering colum its a hard part to come by. Literally you have to rip arpat the steering colum to get at it.

On 1994 Pontiac firebird where is the vats located


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.