The first step is to take out the headlight for easier access. Then you have to take off the very bottom most plastic under bumpuer peice. From their you take out the two bolts located on the top of the light and then there is one under the light. Then you take the screw out of the round peice on the light where you will find the light bulp that just snaps in and out.
How do you replace a front indicator bulb in a Saab 93
the position light bulb is located towards the inside of the headlamp. Its the small "peanut" type bulb. You can access it by removing the high beam bulb and some needle nose plyiers should do the trick.
i dont think you can
You did not include year of the Saab 9-3 so in general here is the tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Change the bulb??
2007 Saab 9-3 tail light bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Take the cover off in the trunk and turn the bulb socket to the left.
Unscrew the lens, replace the bulb, and put the lens back on.
you dont you get a new car
It is a Philips 2040 Halogen bulb. Expensive too..About $9 each.
Open the hood, remove the rubber cover for the high beam bulb (inboard bulb, closer to the radiator), remove high beam bulb and next to it inside the light assembly is the position light bulb. Using a pair of long and 45degree needle nose pliers gently grab the position light bulb socket and pull it straight out! Do not pull on wires and I had to remove my air filter box cover to get my big hands behind the light assembly! Bulb is a W5W, buy it before starting this job!
Open the hood, remove the rubber cover for the high beam bulb (inboard bulb, closer to the radiator), remove high beam bulb and next to it inside the light assembly is the position light bulb. Using a pair of long and 45degree needle nose pliers gently grab the position light bulb socket and pull it straight out! Do not pull on wires and I had to remove my air filter box cover to get my big hands behind the light assembly! Bulb is a W5W, buy it before starting this job!