Remove the covers to the steering column, then use a small screw driver and push in tab on bottom of cylinder with key in run position and pull out.
You will have to destroy the old one to remove, possible by drilling straight through it.
do you mean the door or ignition?
how to remove lighter socket from 2013 dodge durango console
this is for a 2002 doge durango, it must be the sameLOCK CYLINDERREMOVALThe ignition key must be in the key cylinder for cylinder removal.# Disconnect negative cable from battery. # Remove upper and lower covers (shrouds) from steering column. # Place shifter in PARK position.# A retaining pin (Fig. 9) is located at side of key cylinder assembly. # Rotate key to RUN position. # Press in on retaining pin while pulling key cylinder from ignition switch.INSTALLATIONThe ignition key must be in the key cylinder for cylinder installation.# Install the key cylinder into the housing using care to align the end of the key cylinder with the ignition switch. # Push the key cylinder in until it clicks. # Replace the upper and lower shrouds. # Reconnect the battery.
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
No, the V6 and V8 transmissions are different.
krysta krysta
Cylinder number eight is the rear passenger side cylinder.
How do you remove drive shaft from a 03 durango
the ignition coil
Cylinder #7 Misfire
In the firewall behind the master cylinder.