To replace the ignition switch on a 1989 Oldsmobile Cutlass Calais, first disconnect the negative battery cable to avoid electrical issues. Remove the steering column cover by unscrewing the screws, then locate the ignition switch attached to the steering column. Disconnect the wiring harness from the old switch and remove it by unscrewing the mounting screws. Install the new ignition switch by reversing the steps, ensuring everything is securely reconnected before reassembling the steering column cover and reconnecting the battery.
Is the Claias 2.3L 2.5L or 3300?
i need an oil pump fro a 1988 oldsmobile cutlass calais where can i buy one? sherryparris@gmail.com
In the computer.
under car in the back by gas tank
it is located under the coils and ignition modual it is mounted under it all, it comes out with the modual, and be careful if it has been there a while you may break it,
My 1986 Olds Cutlass Calais doesn't have a serpentine belt. It has a separate alternator belt. How do I change it?
Was there a 1984 Oldsmobile Cutlass Calais? I see them listed at 1988-1991. Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, ALL 1988-1991 Oldsmobile Cutlass Calais' have 3/16" Side Lock wiper arm attachments. See Sources and Related Links below.
If a 4 cyc, on the passenger side of the engine, seen from the top.
The Oldsmobile Calais, also known as the Cutlass Calais, was produced by General Motors from 1985 to 1991. In 1987, the Quad 4 engine was developed and the 1988 Calais was fitted with it. All?æof the Quad 4 14 engine types of the 2.3 liter version are interchangeable on the 1988 Calais.
rear tire wall under car tw mills
If it's a Cutlass Supreme (RWD), 4 speed is a TH-200r4. 3 speed is a TH-250. Not sure about the FWD cars (Calais, Cierra).
the library should have a shop manual for this vehicle, you can make copies of the right sections :)