Remove the 8mm bolt in the front, center after removing the belt. Mind the spacers/shims that come out. You may need to use them again. Install is reverse of removal.
yes,a good parts man will give you a belt to bypass your ac.
trying to replace the ac clutch on my f350 6.0 and the bolt up front seems to be a special one any sugestions
Do y need puller to replace ac clutch on compressor. 2004 expition
Take it to a Ford Dealer.
how do you replace the AC compressor clutch on 2006 liberty
the clutch on your A/C compressor needs to be replaced.
You will need a special puller available at automotive parts stores.
there are three bolts under the transmission case by the converter clutch butterfly valve take them off and its under there but make sure you have completely removed the gasket
To replace the AC clutch and pulley on a 2002 Ford Explorer Sport Trac, first, disconnect the negative battery cable and remove the serpentine belt. Then, use a suitable puller to remove the clutch from the AC compressor, followed by the pulley. Install the new pulley, followed by the clutch, ensuring proper alignment, and reattach the serpentine belt. Finally, reconnect the battery and check the system for proper operation.
134a
The ac clutch is held on with a single nut, and can be removed with a remover tool. It the tool will not fit in the space available, then the entire compressor will have to be removed to replace the clutch.
The AC clutch on a ford FS-10 is mounted on the front of the compressor. The clutch is removed by using a puller after the clutch nut is taken off. Mount the puller, and turn the center bolt. This will pull the clutch off of the compressor shaft.