The gas tank must be removed. First disconnect the fuel neck from behind the fuel door. Next remove all of the bolts for the heat shield, remove heat shield. Disconnect the gear clamp from the back side of the filler neck. Now you will need to release the tank straps via two bolts prevously covered by the heat shield. Lower the gas tank using a floor jack. The pump wires and hoses are long enough for the tank to set on the ground without disconnecting them. Now the filler hose is accessable remove the gear clamp and pull it of of the tank.
How do replace fuel filler hose on a 96 ford e-150 v8 van
where is fuel filter located on a 1992 ford ranger
If your 2001 Ford Ranger is a FFV your 8th " character " of your VIN will be a " K " and there will be a label inside the fuel filler door indicating that it is a flexible fuel vehicle
Unscrew it at the top and unclamp it at the bottom.
Take it to a repair shop.
To replace the fuel filler cap on a Ford Fiesta, first ensure the vehicle is turned off. Locate the old cap by opening the fuel door, then twist it counterclockwise to remove it. Take the new cap and align it with the filler neck, twisting it clockwise until it clicks securely in place. Close the fuel door, and you’re done!
Remove the filler neck assembly then wiggle a siphon hose down into the tank. Be careful not to allow dirt and crud get into the tank.
pull your fuel tank out and fuel hoses w/ filler neck it goes in the top of the tank where the circuler ring is
pull off the wires then disconnect the fuel rail then pull up on the injectores
Yes , the 1994 Ford Ranger has fuel injected engines
Yes , a 1991 Ford Ranger has engines that are fuel injected
how to inspect fuel filler hose on 2004 subaru outback