0
How do you replace the ignition control module on a 1983 Z28 camaro with Cross Fire Injection?
you remove the distributor cap and the module should be underneath make sure you get the right one there are 5 prong and 7 prong modules also make sure you put the heat dispursing grease on very thick this will keep it from over heating and rendering your car usless for about 5-10 hours
What else can I help you with?
Where can you replace the ignition key to your 1990 Chevy Camaro?
the ignition keys are dealer only items.
How can I replace the lost ignition key on my 1983 camaro?
You will more than likely have to get a new ignition and key for it.
How do you replace the ignition switch on an 84 camaro z28?
I don't know thats way I ask
Why does your ignition turn the wrong way on your 1979 camaro can not get the ignition to turn forward only back. can not start?
Replace the tumbler assembly, it is broken.
When did the Camaro switch to fuel injection?
Chevy swtitched some of Camaros to fuel injection in the mid 1980's. By 1988 every Camaro engine came with Fuel injection.
How do you change the ignition switch in a 1988 Chevy Camaro?
How do i change the ignition switch in a 1988 Chevy camaro
What is the cause for no ignition in a 87 iroc z28 camaro?
bad coil, bad ignition control, bad ecu, blown fuse and or switch need more info
What electrical problems cause 1987 camaro not to start?
dead battery, or a bad ignition control module inside the distribureator.
Does a 1980 Chevy Camaro have a computer in it?
No, a computer controlled Camaro did not come around until 82, with the Crossfire Injection.
Where is the fule filter located on a 97 Camaro?
where is the main fuel filter located on a 1997 Camaro rs with fuel injection
How do you replace a power window switch for a 1993 Chevrolet camaro?
pry out the control switch and disconnect the electrical connectors.install is reverse.
GM scanner found code 43 on 1989 Camaro referring to Electronic spark timing ESC circuit - low voltage detected or Electronic spark control circuit problems what and where is this and how to fix it?
replace the ignition module Its under the rotor inside the distributer cap
