To remove the dashboard from a 1998 Mercury Mystique, start by disconnecting the battery to ensure safety. Then, remove the screws and clips securing the dashboard, which are typically located around the instrument panel and under the trim. Carefully detach any electrical connectors for gauges and controls, and gently pry the dashboard away from the mounting points. Make sure to keep track of all screws and connectors for reassembly.
That's the overdrive off light
A malfunction has been detected
Correct Amount2000 MERCURY MYSTIQUE 2.5L 6-cyl Engine CAPACITIESEngine, with filter 5.8 qts2000 MERCURY MYSTIQUE 2.0L 4-cyl EngineCAPACITIESEngine, with filter 4.6 qtsyeai thought that a 2000 was a 6 cyl but if it IS a 4 cyl then no more that four quarts...add three and a half check it ...top it off...etc -bilodeau
In the ( 1997 ) Mercury Mystique : The fuel pump shut off switch ( inertia switch ) is in the drivers footwell behind the kick panel ( there is an access hole ) * it's near the inside hood release *
i have the same car. you find it by following the top radiator hose and take the 3 bolts out of the housing. take the hose off and there it is
i have a 1999 cougar mercury vehicle that all of a sudden doesn't reverse.Why?
If it is the same as the ( 1996 ) model year of Mercury Mystique , the fuel pump shut off switch ( inertia switch ) is in the drivers footwell , behind the kick panel ( there is an access hole ) * near the inside hood release
In a ( 1996 ) Mercury Mystique the fuel pump shut off switch ( inertia switch ) is in the drivers footwell behind the kick panel by your left foot . There is an access hole through the panel
Jack the motor up and take the motor mount loose on the top right side. Carefully lower the motor down until you see the crankshaft bolt on the bottom. Then take the center bolt off the crankshaft and then the pulley will come off.
You need to discharge the lines first, then you need a specific tool to take it out. You are better-off letting the professional do it.
In the drivers footwell , behind the kick panel ( there is an access hole )
first, take the door panels off. next, there are four screws you have to remove. after that the speakers can be removed from the door, do not forget to disconnect the wiring harness from the speaker.