0
How many quarts of trans oil needed to change fluid and filter only of 97 Plymouth grand voyager?
Wiki User
∙ 11y ago
Fluid and filter change should require 5-6 quarts.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How much oil does a Plymouth Voyager take after changing the oil and oil filter?
4.5 to 5 qts depending on the engine. with all engines (that are available in this vehicle) start with 4.5 and top off as needed after starting the engine.
Tools needed toinstall front brake pads on 1991 Plymouth voyager van?
you will need a c-clamp and screwdriver and ratchett set.
How much oil is needed to do an oil and filter change on a 1986 Suzuki Intruder?
Take 3 quarts with filter change
How many quarts of oil are needed for a 2006 infiniti g35x?
5 quarts US w/ oil filter change. Always change the filter. 5 quarts US w/ oil filter change. Always change the filter.
What tools are needed to change fuel filter on a 1989 Honda Accord?
oil filter toolYou would need a oil filter wrench, a jack that's all you need to change the filter.
What is the correct tool needed to turn off your maintenance light on a 1990 Plymouth voyager 3.3?
You can reset the light by disconnecting the battery cable for about 5 minutes, then reconnect. You will need a scan tool.
How do you change a fuel filter on a 2003 Tahoe?
is a special tool needed
What is the transmission fluid capacity for a fluid and filter change in a 2003 Chrysler town and country?
Fluid needed after filter change is normally about five quarts.
How do you replace the water pump on a 1994 Plymouth Voyager?
The process of replacing the water pump varies dependig upon the engine size Please post the engine size and will try to provide you with the needed steps
How many quarts of oil are needed for an oil change for an amc 258?
5 quarts if you change the filter.
How do you change fuel filter on 2010 Ford Fusion?
no fuel replacement needed
What are possible reasons for screeching noise in 1997 Plymouth voyager sport rally minivan?
Assuming it is screeching in the area of the belt and pulleys, my problem was that the belt tensioner had seized and needed to be replaced. Noise problem was solved.
