Most are 36 mm. Mark
It should be a 36mm socket.
Remove the ashtray and slide the panel beside where it was, to the right into the position where the ashtray was. This should then reveal the diagnostic socket.
1. Unplug from voltage. 2. Remove lamp. 3 Remove socket from stand. 4. Replace old socket with new socket.
Remove the trim from around the shifter. You should see the light bulb socket. Remove the socket and replace the bulb. As far as the heated seat switches you can replace the light bulb. You have to remove the switch and take it apart. Once you have it apart you will see the bulb. You have to remove the bulb from the little socket. Take it to radio shack they should have one to fit.
A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.
The power supply should be disconnected first. Then comes the CPU cooler. Then the processor can be safely removed from the socket.
If it's the same as the 2000 it looks relatively simple. Remove the plastic trunk liner by hand and then use a socket wrench (7/16" socket- most likely) and remove 4 nuts- It should then wiggle free.
For Axle Nut its 30mm
If you don't have the tool a 13mm socket should work
how to remove lighter socket from 2013 dodge durango console
remove socket with item stuck get screwdriver push threw and watch out for palm!
# Find the circuit breaker or switch that controls the wall outlet and turn it OFF. # Remove the faceplate. # Remove the upper and lower screws holding the wall socket in place. # Remove the two wires from the back or sides of the socket. Installation is the reverse.