answersLogoWhite

0

Engine coolant in an Alero is used in the radiator. A diagram and instructions for how to properly use the coolant can be found on the package instructions. An owner manual will also assist in proper use of coolant.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How much coolant does the 2000 Oldsmobile alero 2.2 engine hold?

A 2000 Oldsmobile Alero with a 2.2 engine will hold approximately 13 liters of coolant. Adding coolant to your vehicle is very important.


Why are the fans running on a Oldsmobile alero 2000 when the car is on?

to cool the coolant in the engine


What is the Olds alero 3.4 L engine coolant capacity?

12.5 quarts - 11.8 L


What does the low coolant warning display light look like on a 2001 alero?

I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner


What type of coolant do you use for 2001 Oldsmobile alero?

Liquid coolant


What sensor bolt into the thermostat houseing on a 2001 oldsmoble alero?

On a 2001 Oldsmobile Alero, the sensor that bolts into the thermostat housing is typically the coolant temperature sensor. This sensor monitors the temperature of the engine coolant and sends this information to the engine control unit (ECU) to help regulate engine performance and emissions. If you're experiencing issues with engine temperature readings, this sensor is a common component to check.


How do you replace a switch -engine coolant level indicator connector on a 2004 Oldsmobile alero?

Purchase a "pig tail" from the dealer and splice it in.


What color is coolant in 2000 olds alero?

Most 2000 GM cars were filled with the RED Dexcool coolant. Using the standard green fluid after the Dexcool has been used can lead to clogged coolant passages and destroy the engine.


How do you bleed the coolant system for 2002 Oldsmobile alero?

To bleed the coolant system on a 2002 Oldsmobile Alero, start by ensuring the engine is cool and the coolant reservoir is filled to the appropriate level. Locate the bleed valve on the engine or heater core, if applicable; otherwise, you can use the radiator cap. Start the engine and allow it to reach operating temperature, then carefully open the bleed valve (if present) or the radiator cap to release trapped air. Once you see a steady stream of coolant without bubbles, close the valve or cap, and check the coolant level again, adding more if necessary.


Where does the coolant fluid go?

Most vehicles have a coolant reservoir (a clear plastic tub) with a phrase "engine coolant only" printed on the cap. This is where you should add engine coolant.


Where is the coolant sensor on a Oldsmobile Alero located?

beside thermostat


What would make a 1999 olds alero keep running hot?

Thermostat, low coolant, inoperable fan, exhaust leak close to engine bay