answersLogoWhite

0

TBI didn't have one, you have to tap into the fuel line at the fuel filter with adapters to attach a pressure gauge. CFI has a test port in the fuel line on top, in back of the engine.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you check fuel pressure on 3.0 V6 Toyota pickup?

To check the fuel pressure on a 3.0 V6 Toyota pickup, you'll need a fuel pressure gauge. First, locate the fuel pressure test port, which is usually found on the fuel rail. Remove the cap from the test port, then connect the gauge to the port and turn the ignition key to the "ON" position without starting the engine to allow the fuel pump to pressurize the system. The gauge should read between 30-40 psi; if it's outside this range, it may indicate a fuel delivery issue.


Where is the test port to test fuel pressure located on a 2002 6 cylinder Chev Malibu?

the fuel pressure (key on engine off ) for a 2002 Malibu v6 is ==2000 and later is 52 to 59, have a good day!!


Is the 1999 bravada fuel injected?

Yes. It has a Vortec 4.3L V6 that is port fuel-injected


Where is the fuel pressure regulator on 4.3 V6 with central multi-port fuel injection?

It is under the intake manifold.


How do you test fuel pressure regulator on 1991 Toyota 4Runner v6?

To test the fuel pressure regulator on a 1991 Toyota 4Runner V6, first, relieve the fuel system pressure by removing the fuel pump fuse and starting the engine until it stalls. Next, connect a fuel pressure gauge to the fuel rail's test port. Start the engine, and observe the pressure reading; it should be within the manufacturer's specifications (typically around 30-40 psi). If the pressure is too low or fluctuates significantly, the fuel pressure regulator may be faulty and should be replaced.


What is the specification for fuel pressure on a 1995 Nissan Maxima with the 3.0l v6?

43 PSI with engine at Idle with Fuel Regulator vacuum line disconnected and plugged.


What is the 1987 Chevy Celebrity fuel system?

The 2.5L 4 cylinder engine uses throttle body fuel injection. The 2.8L V6 uses multi port fuel injection.


What is the recommended fuel pressure for a 1989 Chevy Corsica?

For the 1989 2.0 4cyl, a low pressure pump is used. That makes pressure between 9 and 13 PSI. The V6 fuel pump should produce between 41 and 47 PSI. Hope this helps!!! BTW v6 is multi-port fuel injected, and the 4 is 'bottom feed port'


Your 2.8 v6 wont start after new fuel pump installed what could it be?

Do you have power at the fuel pump relay test connection. do you have fuel at the schrader valve on the fuel rail.


Why is your 2001 Chevy Blazer LS V6 4x4 taking longer to fire than before?

Probably the fuel pump is on its way out. Have a fuel pressure test done.


What type of fuel system does a 1992 Dodge Dakota have?

The four cylinder has a throttle body injected gas engine.The V6 and V8 are a multi port injection gas engine.The four cylinder has a throttle body injected gas engine.The V6 and V8 are a multi port injection gas engine.


1998 Dodge Stratus ES 2.5 V6 Is there a way to test the fuel injectors?

i paid a cheny dealer to test my injectors and it cost 150.00 for the test. that is the only way to get then tested is to have a mechanic do it