0
The plug is located on the driver's side of the vehicle, tied to the back wall, close to the top of the engine compartment, in between the Power Steering reservoir tank and the battery. It has a orange-ish colored cap on the end of it which protects the outlet prongs. You will need cutters to cut the wire tie. The cord is "flat" and will reach to the front of the vehicle when it's untied.
What else can I help you with?
Where is the block heater plug in on a 2000 Mazda tribute?
There may not be one.
How to replace block heater cord on 2000 Malibu?
To replace the cord for a block heater on a 2000 Malibu, unplug the old cord from the block and plug in the new one. The end of the block heater cord can be found by tracing the cord back to where it is plugged into the motor.
Where is the block heater plug on a 2000 Toyota Celica GTS?
there is no block heater plug block heaters are mainly used on diesel applications during the winter to help keep the block warm and makes it a whole lot easier to start
Where is the block heater plug-in located on a 2000 Pontiac Grand Prix GTP 3.8L V6 Supercharged engine?
If there is a block heater installed then there should be a plug at the hood/lights or bottom of engine.
What do you plug a block heater into?
plug a block heater plug into any household 120 electrical outlet just like plugging in a heater in your house
Where is the plug for a 95 cadillac block heater?
The 1995 Cadillac block heater plug can be found on the right hand side of the engine. The block heater plug will be near the back of the engine.
Is there a block heater frost plug on a 1997 geo tracker If so where is it?
The 1997 Geo Tracker block heater does have a frost plug. The Frost plug will be a few inches below the block heater.
1992 Saturn where the engine block heater plug is located the 110 plug?
where is the heater block on a 2004 saturn vue?
Where do locate an engine block heater on an 2000 dodge sprinter?
The Dodge Sprinter did not come out until 2002. The heater is an add on option that is installed in a freeze plug on the passenger side of the block.
How do you install block heater 2003 ford windstar?
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.
Where is located block heater plug 4300 international truck?
The block heater plug on a 4300 International truck is located just behind the battery. A heavy duty outdoor cord will be necessary to plug the block heater into an electrical outlet.
Where do you plug in a block heater cord on a 2006 Chevy Trailblazer?
Usually the block heater is in place of the passenger's side rear freeze plug
