answersLogoWhite

0


Best Answer

every time i see your face i doo doo every day doo doo, doo doo, doo doo, everyday.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the location of relay switch blower Chevy astro 2002?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Blower control switch 1996 Chevy Astro?

yes


Where is the rear ac blower on Chevy Astro?

where is the rear AC blower on the Chevy Astro 98


Location of blower relay in 1989 Chevy Astro van?

under the hood on the passenger above the blower motor mounted to a bracket.


How do you troubleshoot heating ac system on 1996 Chevy astro Van that blower does not work and have checked blower motor it is good and have replaced relay resistor what else can it be.?

fuse? switch? Selector?


Location of o2 sensor of 98 Chevy astro van?

location of 3 sensor of 97 Chevy astro van?


Blower not working on a 99 astro?

Check the following................ 1. Power and ground to the blower motor. 2. Blower resister. 3. Blower switch.


Where is the fuel relay switch located on a 97 Chevy Astro Van?

The 1997 Chevy Astro fuel relay switch is located on the firewall in the engine compartment. The fuel relay switch will be in the center of the firewall.


1988 Chevy Astro only blow air through the windshield what is wrong?

I have a 2003 astro with the same problem, it was the blower motor


Why is the AC air cold and the blower is working but no air is coming out of the vents on a Chevy Astro van 6 Cy?

Vacuum hose that runs over the thermostat housing is leaking at that location.


Where is the blower motor located on a 1997 Chevy Astro Van?

The Blower motor is under the hood, passenger side. It has a purple wire attached.


Where is the fan relay switch on a Chevy Astro van?

johnny frank


How do you replace the ignition switch on a 2002 Chevy Astro van?

You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.