answersLogoWhite

0

I'm an ASE Certified Diagnostic Technician with about 20 years under my belt. I'm dealing with a similar problem at present. I believe the first step is to ensure you are correctly identifying the component your referring to, there are several components that can easily be misidentified as a "computer". Once you know the components actual name (pcm or powertrain control module is correct in your case), you will need a list of pins (or "pinouts") on the related connector(s) and their relevant values (in this case KOEO (Key On - Engine Off)). Now the priority is to utilize a DVOM (Digital Volt Ohm Meter) to verify the integrity of the power supply wires and ground wires. You can do this easiest by detaching the connector(s), and probing the correct pins for the value in volts.

note: If you must purchase one, then be sure that it has at least a 20 Mega-ohm impedance or more. Any less and you chance harming your computer if it is still functional.

Once that is done, assuming you know how to use the meter correctly, you can continue testing the sensors and actuators also connected to the remaining pins in the connector(s). If all the values are as expected according to the list you attained, it would be safe to condemn the pcm as faulty.

this procedure is required by all new/reman computer dealers for a good mechanics to have any warranty honored.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

When you start your computer you hear a clicking you can hear a clicking sound and then it wont start up?

I actually had this problem with my first xbox. It turned out to be the hard drive.


2002 f150 clicking noise wont start?

Low battery voltage .?


Why wont my 2005 Ford Taurus SE start. It wont even crank. What could be wrong?

it might be the starter. have it checked out.


Your 97 Taurus wont go anywhere when you press the gas?

start the engine first!!


Dodge Durango won't start battery ok clicking noise but then stopped clicking?

check your battery then the connections if it still wont start try changing the starter solenoid if possible


96 Olds aurora wont start clicking noise from under the front panel.?

If the 1996 Olds Aurora will not start and there is a clicking noise from under the front panel, check the starter. The clicking noise is probably from the starter solenoid.


Toyota MR2 wont start clicking noise whentrying What is wrong?

dead battery or bad starter (with the clicking, I'm 95% sure its the battery)


Ford truck wont start due to low spark?

Ford F-150 will not start all it does is make a clicking noise


Why wont my Rover 420 diesel start this morning has a clicking sound?

Jump start car and ensure alternator and battery are good.


1999 Saturn wont start just a clicking noise and battires are fine?

Either your starter or ignition..


Your 1994 wrangler wont start until you hear a clicking in the front somewhere it will turn over but wont start if you keep trying you will eventually hear the click and it will start?

sounds like you have a bad ignition switch or a bad starter solenoid


Your Massey Ferguson 35 will not start unless you jump start it from your car is a new battery needed?

new battery installed . push starter and all I get Is a humming sound . wont turnover though