answersLogoWhite

0

Bad seal in light fixture

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you seal a leaking tail light?

I'm not sure how to seal your leaking tail light...but I had the same problem, even after replacing the original tail lights years later, I ended up with the same problem with the new tail light assemblies. Anyway -- since I wasn't able to seal the tail light assembly, I took the tail light off the car and in the top of the tail light assembly above the area where the water was leaking in I drilled a small hole (that you couldn't see when the light was reinstalled) and then a slightly bigger hole on the bottom of the light where the water collects. The air flowing through the top hole forced the water out of the bottom hole. Start with real small holes and increase a little at a time if needed. I hope this will satisfy you problem.


How do you seal a leaking brake lamp?

I'm not sure how to seal your leaking tail light...but I had the same problem, even after replacing the original tail lights years later, I ended up with the same problem with the new tail light assemblies. Anyway -- since I wasn't able to seal the tail light assembly, I took the tail light off the car and in the top of the tail light assembly above the area where the water was leaking in I drilled a small hole (that you couldn't see when the light was reinstalled) and then a slightly bigger hole on the bottom of the light where the water collects. The air flowing through the top hole forced the water out of the bottom hole. Start with real small holes and increase a little at a time if needed. I hope this will satisfy you problem.


How do you replace tail light on 2002 Monte Carlo?

Open trunk, locate inside of tail light, unscrew thumb screws behind tail light. Pull out tail light. Be careful not to drop it. Keep one hand on the outside of the tail light.


How to Replace c230 kompressor tail lights?

Begin I removing the tail light connector. Take hold of the tail light, push in and turn at the same time. The tail light will come on. Reverse the process to install your new tail light.


How do you Replace tail light 1995 buick century?

you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.


How many volts should you get from tail light?

Depends on what kind of tail light. An older tail light should have 12 v, but more modern tail lights are from LEDs.


How do you fix a tail light in a Kia Rio cinco?

In order to fix a tail light in a Kia Rio Cinco you must first locate the tail light. Then, undo the tail light and replace it with the new materials and put the cover back on.


How do you get to the rear tail light to change it on a 94' crown Victoria?

on the tail light problem - unbolt the tail light from inside th truck -the hold tail light assemble will come out - it is recommended to change all the blubs your all ready there


How do you install tail light bulb Chevy Cobalt 2006?

Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.


Is the tail light and dash light fuse the same on a 2001 silverado?

The dash light fuse gets its power from the tail light fuse. If the tail light fuse blows, you won't have any dash lights either.


How do you remove a tail light Cadillac xlr?

To remove the tail light from a Cadillac XLR, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips securing the access panel and pull it away. Next, disconnect the wiring harness from the tail light, then unscrew the tail light assembly from the vehicle and gently pull it out. Finally, replace the tail light by reversing the steps.


How do you change tail light in Toyota sequoia?

How do you change the tail light on a 2001 toyota sequoia