i have a 96 dodge avenger 2.5 and it keeps blowing my ignition switch. any idea why?
A fuse that keeps blowing is an indication of a malfunctioning ignition. The ignition may be the culprit or the wiring leading to the ignition may be the problem.
You have a ground wire that isn't grounded causing a shortage therefore blowing the fuse....I would start with the ground wire that is connected directly to the starter itself
could the pcm fuse be blowing because of a short in the air conditioning switch I have seen the starter be the cause of a blown pcm fuse.
I believe the starter solenoid is on the same circuit. A failed starter is most likely the problem.
there is a fuse under the hood for "fuel ingtion system" # 20 amp change that im searching why my car keeps blowing the same fuse
You will need to replace your starter, this happened with my car a couple days ago, I brought it into the shop, got the starter replaced and the fuse does not blow anymore. It happens because the starter draws to many Amps of electricity due to age, amount of use etc.
I assume you mean the fuse keeps blowing? It's certainly possible for the lighter element itself to go bad as well as the socket you plug it into. Also, there are often other circuits that use the same fuse.
Disconnect the harness at the fuel pump and replace the fuse. If your fuse doesn't blow after turning the ignition on, you probably have a bad fuel pump, check it for shorts.
the starter has failed.
your car wont start!
Failed pump, or wiring shorted to ground.