0
yes and no their are off set bolt holes on a 350 engine chevrolete because their are two diffrent fly wheels if you have the small fly wheel then your holes off set each other on your starter if you have the large fly wheel then the holes go straight a cross if their is a plug you have to snap into get replacement plug (napa, dealer about $13) connect replacement plug into old start wire just tie into it tape up old wire in case you ever need to switch back and you done
What else can I help you with?
Where is the starter at on a 1992 Chevy Lumina apv?
under the engine
Where is the knock sensor on a 1992 Chevy 454SS?
It is over by the starter and screewed into the engine block.
Where is the starter located on a 1992 Chevy s10?
Backside, lower, passenger side of engine.
Where is the starter located on a 1992 Chevy Corsica?
On a 1992 Chevy Corsica, the starter is located on the driver's side of the engine, near the bottom of the engine block. It is mounted to the transmission bell housing and can be accessed from underneath the vehicle. To replace or service the starter, you may need to remove the battery and some components for better access.
Where is the solenoid on 1992 Chevy s10 blazer?
The starter solenoid is attached to the starter.
Can a distributor from a 1992 Chevy c-1500 350 engine electronic advance work on a 1969 396 Chevy?
yes as long as you swap electric parts
How does a shim go on a starter for a 1992 Chevy Lumina?
between starter housing & block
How do you remove starter solenoid wires from 1992 Chevy S10 blaze when space is lacking for tools?
Remove the two bolts holding the starter to the engine then you should be able to drop the starter down enough to take the wires off and remove the starter.
Can a distributor from a 1992 Chevy c-1500 350 engine work on a 1969 396 Chevy?
No the distributor gear that is on the end of the distributor is to small for the big block cam shaft.
Where is the starter relay on a 1992 pathfinder?
The starter relay on a 1992 Pathfinder is mounted between the transmission and engine block. The starter uses a gear drive to crank the engine and help it start.
Where is the knock sensor located on a 1992 Chevy s10 blazer with 4.3 V6 eng?
It is screwed into the passenger side of the engine block just in front of the starter.
How many knock sensors are on a 1992 V6 4.3 Chevy s10 engine?
Just 1 and it is screwed into the passenger side of the engine just in front of the starter. It will have 1 electric wire hooked to it.
