answersLogoWhite

0


Best Answer

I do not believe there is a metal bumper. There is a foam insert that goes inside the bumper cover.

User Avatar

Wiki User

โˆ™ 2011-09-13 06:22:26
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

โžก๏ธ
See all cards
1.0
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
1 Review

Add your answer:

Earn +20 pts
Q: How do you remove the front plastic bumper cover of a 1999 Jeep Grand Cherokee Laredo to access metal bumper?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to remove the radiator on a 2001 jeep grand Cherokee Laredo with air cond?

First remove the front clip (headlights and grille and plastic covering the bumper.) The rest will be obvious.


Does the 1999 Jeep Grand Cherokee Laredo have a hitch?

Some do, some don't. If it does you can see it at the rear bumper.


How do you remove the front bumper cover from a 2000 Jeep Grand Cherokee?

how to install 2000 jeep grand cherockee Laredo front bumper cover


Does a 1997 Jeep Grand Cherokee Laredo have 2 horns?

yes, they are located in front rigth side under the bumper


Is 2004 Jeep Grand Cherokee Laredo wired for fog lights?

YES. The harness is behind the bumper in proximity of the location of the lights.


Is the 2004 jeep grand cherokee laredo prewired for fog lights?

YES. The harness is behind the bumper in proximity of the location of the lights.


How much for a Jeep Cherokee Laredo 2007 front bumper?

Around 365 CAD + tax and plus the extra cost of paint.


Where is the gas tank in a 1995 Jeep Cherokee?

It is in the rear, right under the rear bumper. There is probably a plastic cover surrounding it.


How does one remove a front bumper from a 1997 Jeep Grand Cherokee?

First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.


How do you change a 1998 rodeo bumper?

I've done it but it was years ago and I'm working from a poor memory. The grill has to come out to give you access to the fasteners holding the plastic bumper cover on. They are held by an ingenious little plastic clip that you access from the front of the vehicle. These "Clips" have to be rotated 90 degrees to unlock them and there are 8 or so total to undo. Look around the edges of the grill and you will spot them. once you get access to the bumper cover there are screws on the top and bottom of the cover that must be removed to get access to the bumper structure. The "bumper itself is pretty easy to replace as it is just bolted to the frame; getting access to it is the trick I think I also remove the headlights to allow access to the bumper cover as well. Good luck.


How do you access the license plate bulbs on a 04 Tahoe?

Try prying the plastic pieces from the bumper. They should jump right out. They are held in by tabs on the plastic housings.


What do you use to attach plastic bumper to bumper?

Super glue

People also asked